- DL manuals
- Abus
- Marine Equipment
- FUSG50100
- Installation Instructions And User Manual
Abus FUSG50100 Installation Instructions And User Manual
Summary of FUSG50100
Page 1
Fusg50100 14 version 1.08 bom 12686955 secvest wireless outdoor sounder en installation instructions and user manual.
Page 2
Contents contents introduction ........................................................................................................................................................................ 3 safety information ..................................................................................
Page 3
3 en introduction information on user manual dear customer, thank you for purchasing this product. This device is built with state-of-the-art technology. This manual contains important installation and operation information (last updated 08/2016 with software v1.8). Follow the directions and instruc...
Page 4
En 4 limitation of liability everything possible has been done to ensure that the content of these instructions is correct. However, neither the author nor abus security-center gmbh & co. Kg can be held liable for loss or damage caused by incorrect or improper installation and operation or failure t...
Page 5
5 en safety information explanation of symbols the following symbols are used in this manual and on the device: symbol signal word meaning caution indicates a risk of injury or health hazards. Caution indicates a risk of injury or health hazards caused by electrical voltage. Important indicates poss...
Page 6
En 6 battery warning information caution caution the device is supplied with direct current from a battery pack. To guarantee a long lifespan and avoid fire and injury, please note the following: do not dispose of the battery with household waste. the battery must not be directly exposed to heat...
Page 7
7 en scope of delivery secvest wireless outdoor sounder 2 x battery pack quickstart guide with important product information installation material technical data product name secvest wireless outdoor sounder product description sounder item number fusg50100 manufacturer abus security...
Page 8
En 8 battery type 2 x 3 v alkaline manganese batteries, 18 ah item number of the replacement batteries: fu2986 (comprises 2 battery packs) battery life 2 years nominal with one activation per month for 3 minutes. Flashing and audio alarm with one arming acknowledgement per day. Acknowledgement f...
Page 9
9 en functional principle and features general the wireless outdoor sounder is an outdoor combination alarm device with siren and flashing light for use with secvest alarm panels. It serves as an optical and acoustic alarm. The sounder and alarm panel communicate with each other wirelessly, so no fi...
Page 10
En 10 note before starting installation, identify a suitable installation location for the wireless outdoor sounder using the wireless test box. Ensure that the sounder is installed out of hand’s reach (minimum 3 m installation height). In addition, the sounder should be visible and audible from a...
Page 11
11 en device description 1 lid fixing screw with cover 2 mounting hole for wall installation 3 mounting holes for tamper mechanism 4 spirit level 5 jumper/connector cover 6 fixing tab for the jumper/connector cover to unlock: push the tabs on both sides outwards 7 jumpers and battery connectors 8 ba...
Page 12
En 12 installation installing the sounder step 1: select installation location for the sounder select an installation location which: is inaccessible to intruders and vandals is located well out of reach (>3 m) is clearly visible, so that it acts as a strong deterrent is within the wireless ...
Page 13
13 en step 4: teach in sounder in the alarm panel if this has not been done already, switch the alarm panel on. place the sounder next to the alarm panel or within range of the alarm panel with which it communicates. select: installer mode -> components -> outdoor sounders -> wireless sounders...
Page 14
En 14 step 5: mount the sounder on the wall note a pin serves as an anti-removal wall contact to activate the tamper switch on the inside of the sounder. To fit uneven walls, the length of this pin can be adjusted. To do this, turn the screw, which is in the pin, either in or out. If the wall tamper...
Page 15
15 en step 6: switch on sounder caution the sounder should not be activated in the following steps. You should, however, be prepared for the fact that the sounder might nevertheless be activated. Make sure that any loud sounds emitted do not startle you, causing you to fall off the ladder. connect...
Page 16
En 16 functions, jumpers and displays installer mode the sounder’s installer mode prevents the sounder and the flashing light from being activated when the cover is opened. Installer mode is activated when installer mode is called up on the alarm panel and is deactivated when installer mode is exite...
Page 17
17 en set conf activates or deactivates the flashing light/beep acknowledgement. If the flashing light is to flash briefly when the system is armed or disarmed, use the alarm panel to enable the “strobe on set” or “strobe on unset” option in the relevant partition. If the sounder is to beep briefly ...
Page 18
En 18 time the tune jumper (off-switch timer) is used to configure the maximum length of time that the acoustic sounder (sounder tone) is active following an alarm. You can choose between five seconds and three minutes. If you do not connect a jumper, a switch-off time of 15 minutes is set. Jumper o...
Page 19
19 en operation of the comfort leds in normal operation, the comfort leds flash alternately if the sounder is connected to the power supply to visually display that the system is operational. When installer mode is activated on the alarm panel, the two comfort leds are continuously on for several mi...
Page 20
En 20 error and tamper monitoring the sounder continually monitors error and tamper states and reports all events to the alarm panel. The following is monitored: tamper contact: the sounder’s tamper contact is continually monitored. The sounder activates itself in the event of tampering. battery...
Page 21
21 en maintenance caution before opening the sounder’s cover, make sure that the alarm panel is in installer mode. This should prevent the sounder being activated. You should, however, be prepared for the fact that the sounder might nevertheless be activated. Make sure that any loud sounds emitted d...
Page 22
En 22 how to replace the batteries: put the alarm panel in installer mode. open the covers for the lid-fixing screws (see fig. 1), loosen the screws and open the lid. remove the jumper/connector cover (see fig. 1) by pushing the two fixing tabs outwards and lifting up the cover at the same tim...
Page 23
23 en warranty note abus products are designed and manufactured with the greatest care and tested according to the applicable regulations. the warranty only covers defects caused by material or manufacturing errors at the time of sale. If there are demonstrable material or manufacturing errors, ...
Page 24
24 en disposal dispose of the device in accordance with eu directive 2012/19/ec – weee (waste electrical and electronic equipment). If you have any questions, please contact the municipal authority responsible for disposal. You can get information on collection points for waste equipment from your l...