Abus RM40Li User Manual - page 32
– 32 –
]| %#7|]
detector in addressing mode too.
`| 7*\Q|
4. The addressing process can take up to 60 seconds. When the detectors have been
successfully trained, the LED on both detectors lights up for around 5 seconds,
*+7|}+
+*\Q|
5. If you wish to connect several detectors together,
+
with which you can connect the other detectors.
Proceed with points 1 to 4 as described to connect
the detectors in a network.
\|+7
with
another.
Reset default factory settings/separate network connections
In order to reset the smoke detectors to the default factory settings
• Press the test button and hold it down.
V*7|];Z+/|V*^
;Z+/7|+|
• Now let go of the button. If a short beep is heard, the procedure was successful.
All network connections between the detectors have then been separated.
Muting the detector
If an alarm has been triggered, the wireless smoke detector can be muted by
pressing the test button. In the case of networked detectors, the mute button on
the activated detector can also silence the alarm of the other networked detectors.
Putting into operation