Acard AEC-7730A Quick Manual

Page of 2

Download

Bookmark us

Chapter 4 Troubleshooting

4.1 Basic Troubleshooting

Inspect the following items if your AEC-7730A cannot work properly after

installation.

1. Inspect if all connectors of SCSI cable and power cord are firmly

connected.

2. Inspect if the SCSI adapter is correctly inserted into the PCI slot on the

motherboard.

3. Inspect if the SCSI adapter’s driver is successfully installed.

4. Check the jumper setting, and be sure that the SCSI ID number does

not conflict with one another.

4.2

Advanced Troubleshooting

Here we only take the advanced troubleshooting in Windows XP as an

example. First let’s check the SCSI adapter.

1. Right click “My Computer”.

2. Left click “Properties”.

3. After entering “System Properties”, click “Hardware”, “Device

Manager”. Then, double click “SCSI and RAID controllers” to see if

your SCSI adapter is installed well.

Now check the SATA HDD connected to AEC-7730A.

1. In “Device Manager”, click “Disk drives” to show your HDD.

2. Right click the SATA HDD and left click “Properties”.

3. Enter “General” to see if the device works normally and the target ID is

correct.

Quick Guide

Version 1.1

Release: June 2007

ACARD SCSI-SATA Bridge

AEC-7730A

- 3 -

Page 1
Chapter 4 troubleshooting 4.1 basic troubleshooting inspect the following items if your aec-7730a cannot work properly after installation. 1. Inspect if all connectors of scsi cable and power cord are firmly connected. 2. Inspect if the scsi adapter is correctly inserted into the pci slot on the mot...
Page 2
Chapter 1 introduction 1.1 overview the development of aec-7730a is based on acard’s scsi-to-sata technology, which converts a sata hard drive into a scsi one for the best performance. An on-board core micro controller developed by acard makes the bridge aec-7730a more flexible and more stable in hi...