Accel DD-SS Digital Delay User Manual - page 2
CONTROLS
Control Knobs:
1) Mix: Controls blend of wet and dry signals
2) Delay: Delay time
3) Repeat: Number of repeats
Switches:
4) Toggle Switch (2 way ): 600ms/1100ms
5) Foot Switch: Toggles effect on/off (indicated by red LED).
DIRECTIONS
With the amplifier turned off. Route a guitar instrument
cable from the GUITAR to the INPUT JACK of effects pedal.
Make sure each end of the cable plug is completely inserted.
With a different cable, route the cable from the
OUTPUT JACK of the effects pedal to the amplifier.
Plug in preferred power source (9V battery, or a 9V effects
pedal adapter or 9V effects pedal power supply output).
Such as our “Power Source 8" power supply, to the effects pedal
POWER INPUT JACK.
Note: The effects pedal POWER INPUT JACK is negative
center polarity, which is the most common in the
effects pedals market. Be sure that the cable plug is also
negative center polarity, or damage to the unit may occur.
Before turning on amplifier turn down al volume and level
controls on your amplifier, pedal and guitar. Turn on amp.
Adjust volume and level controls on amplifier, pedal and amp.
SPECIFICATIONS
Size:
Input Impedance 1 MS
Output Impedance <7.5 kS
Noise Floor* >88 dB
Current Draw 2.2 mA
Bypass Hardwire
Power Supply 9 volts DC