Accent Acoustics Hide & Seek Owner's Manual - page 4
Receiver / Amplifier:
Receiver / Amplifier:
Receiver / Amplifier:
Receiver / Amplifier:
Now connect the Seek
Seek
Seek
Seek satellite speakers to your receiver /
amplifier’s speaker terminals as per Fig 6. (Please refer to
the receiver’s owner’s manual for the manufacturer’s
connection recommendations).
Fig 6
Subwoofer Connection:
Subwoofer Connection:
Subwoofer Connection:
Subwoofer Connection:
To connect the subwoofer to your receiver / amplifier you will require an RCA style cable, as shown in Fig 7
(supplied). Connect one end to the terminal marked LFE on the rear of your
subwoofer (Fig 8).
Refer to your owner’s manual for the correct connection point for your Hide
Hide
Hide
Hide Subwoofer on your
receiver / amplifier.
Electronics manufacturers may call this connection by one of the following:
1) Sub Pre Out
2) Sub Out
3) LFE Output.
4) Subwoofer out
Two additional terminals are also provided on your subwoofer, these accept signals from receivers equipped
with left and right stereo outputs. Longer Subwoofer cables are available from your retailer.
Speakers:
Speakers:
Speakers:
Speakers:
The Seek
Seek
Seek
Seek is fitted with quick fit spring terminals.
Simply push down firmly until the terminal stops,
insert cable and release.
Ensure all strands of the wire pass through the
connector as loose strands can damage the
receiver / amplifier.
Fig 7
Subwoofer Controls:
Subwoofer Controls:
Subwoofer Controls:
Subwoofer Controls:
The power switch connects / disconnects the subwoofer from mains power.
(If your receiver has a 240 Volt power outlet DO NOT
DO NOT
DO NOT
DO NOT connect to this socket, your receiver will not provide
the necessary current to power the subwoofer correctly and receiver damage may occur).
LED Indicator Light
LED Indicator Light
LED Indicator Light
LED Indicator Light:
Red indicates that the mains power switch is on and that power
is available. Green indicates that either the power on mode switch
is set to “on”, or in “auto” mode (if low frequency signal is available from the receiver).
Crossover:
Crossover:
Crossover:
Crossover:
Please adjust the Hide
Hide
Hide
Hide subwoofer crossover control to the Seek
Seek
Seek
Seek setting see Fig 9.
Power ON Mode Switch:
Power ON Mode Switch:
Power ON Mode Switch:
Power ON Mode Switch:
ON: Always on
Auto: Auto power on when a signal is present. If no sound is detected, a timer will switch
the subwoofer off automatically. (This may take up to 15 minutes)
Subwoofer Level:
Subwoofer Level:
Subwoofer Level:
Subwoofer Level:
Set this control to the 12 o’clock position for calibration setup. This allows flexibility for
quick changes of volume control without entering the receiver’s set up menu (If required).
Fig 8
Making the connection:
Making the connection:
Making the connection:
Making the connection:
Setting up your Hide & Seek 5.1 High Fidelity Speaker Package
Setting up your Hide & Seek 5.1 High Fidelity Speaker Package
Setting up your Hide & Seek 5.1 High Fidelity Speaker Package
Setting up your Hide & Seek 5.1 High Fidelity Speaker Package.
Fig 9