Accessibility Professionals 30911 Operating Instructions Manual - Guardian Alert 911
Guardian Alert 911
tm
15
Step 3 – Make sure the PENDANT and the BASE UNIT are communi-
cating with each other.
Background information: The PENDANT and the BASE UNIT are con-
nected by a wireless radio link. They must be synchronized to work together.
They should have already been synchronized at the factory, but resetting this
is simple.
What to do:
1. Press the “SET UP” button on the BASE UNIT until the red
“SCANNING” light comes on. Release the SET UP button.
2. Now press and hold the PANIC BUTTON
and the TEST
BUTTON buttons (on the pendant) at the same time until the
“SCANNING” light on the BASE UNIT turns off. It should
turn off right after you push both buttons together.
What to expect:
The red light on the BASE UNIT will go out immediately after
the 2 buttons are pressed at the same time. This indicates the
PENDANT and the BASE UNIT are synchronized. At this
point, everything should be working fine.
Now perform the System Check (pg 11) test again to make sure all is well.
If your Guardian Alert 911 is still not working, call our TECH SUPPORT
department at 703-934-7934.
Information The FCC Wants You To Know:
FCC ID: TYD30911
This device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
Privacy of communications may not be ensured when using
this phone.