Accton Technology Cheetah EtherCard-2320 Quick Installation Manual - Installation
Cheetah EtherCard-2320
3
Installation
1.
Select an empty CardBus PC Card slot and insert the Cheetah
EtherCard-2320 into that slot as shown below.
2.
Connect the Cheetah EtherCard-2320 to a network hub or
switch using UTP cable with RJ-45 connectors. Use Category
3, 4 or 5 for 10 Mbps connections and Category 5 for
100 Mbps connections. The UTP cable should have a
maximum length of 100 m (328 ft).
3.
Power on your PC and install the appropriate network driver
for your operating system. Drivers can be found on the Driver
Diskette.
Notes: 1.
The card auto-negotiates the speed and duplex mode of
the network connection, providing seamless operation
on either 10 or 100 Mbps segments.
2.
Full-duplex communications allows data to be sent and
received simultaneously, doubling the effective
throughput. Refer to the readme files on the driver
diskette for information on setting the duplex mode.
Driver Installation and Configuration
The diskette labeled “Driver Diskette,” that comes with the
package contains all the software drivers available for the Cheetah
EtherCard-2320. A RELEASE.TXT file, describing the contents of
the diskette is found in the root directory. Different drivers are
stored in separate subdirectories, which also include a text file.
Select the driver you need for your system and refer to the text file
for the installation and configuration procedure. Any new or
updated drivers can be downloaded from Accton’s Web site at
http://www.accton.com.
68-pin connector
ACT
LINK