ACCU-JOGGER ACCU-JOGGER Instructions For Use - page 2
b) Connect the plug supply unit of the ACCU-JOGGER to a 230V socket. Establish beyond doubt that
the socket is actually carrying a constant current.
c) Connect the ACCU-JOGGER to the lead accumulator. Attach the red clip to the positive pole (+),
and the black clip to the negative pole (-). NEVER mix up the connections, not even on a test basis.
d) Do not wrap up the ACCU-JOGGER in cloths or carton etc during operation. Air must be able to
circulate freely around the casing opening.
5. THE ACCU-JOGGER IN NORMAL OPERATION
The device starts the cyclical charge and discharge process automatically. Depending on the charge
status of the accumulator, the ACCU-JOGGER begins here either to charge or to discharge. A
complete charge/discharge cycle can take a few minutes in the case of small batteries, or several days
in the case of large batteries. Charge and discharge times can vary.
If the lead accumulator is discharged, then the ACCU-JOGGER quickly switches initially from
“CHARGE” to “DISCHARGE”. This cycle extends, until finally the green LED indicates a constant
charge phase, which can continue for several days.
If the cycle does not become longer, then the battery no longer has sufficient capacity and must soon
be replaced.
Important: check the acid level of the lead accumulator every 8-12 weeks.
Troubleshooting indication: if, when the device is connected, the charge/discharge cycle still does not
begin, please check the following points:
a) Does the socket carry a current?
b) Is the lead accumulator defective or totally discharged? (See 3.)
c) Is the ACCU-JOGGER reverse-connected? (Correct: RED=PLUS, BLACK=MINUS).
6. FINISHING THE CHARGE OPERATION
a) Detach the connection clips of the ACCU-JOGGERS from the lead accumulator.
b) Withdraw the plug supply unit from the socket.
c) Check the acid level of the lead accumulator and, if necessary, fill up with distilled water.
d) If necessary, install and connect the lead accumulator in the vehicle again. The safety indications
provided by the vehicle and battery manufacturers must be observed in the process.
e) Store the device in its original packaging in a clean and dry location.
7. TECHNICAL DATA
6V
version
12V
version
Max. charging current : 200mA 300mA
Max. discharging current:
100mA 100mA
Lead accumulator capacity: 6V / 5-100AH 12V / 10-250AH
Supply voltage : 220V-240V / 50/60Hz / 7 watt (max)
Special feature
:
short circuit resistant
8. CONDITIONS OF WARRANTY
Your device was manufactured in accordance with the most progressive industry standards and
underwent repeated quality control testing and a measuring test. We grant a 24-month warranty from
the date of sale. Should defects arise in this period as a result of structural flaws, these will be
remedied for you free of charge by repair.
Right to claim under warranty
Recognition of a right to claim under warranty is the sole responsibility of the manufacturer. All rights
to claim under guarantee cease to exist immediately in the case of undesirable interference,
mechanical damaging or damage as a result of improper handling.
Services under warranty can be granted and performed only by the manufacturer.
Repair period
for the repair of a device under warranty generally amounts to 20 working days.
Claims for compensation
of all kinds, in particular as a result of consequential damages, are excluded. Liability in all cases is
confined only to the value of our product.