Accu-Scope 3078 Series Manual - page 9
3078-ZOOM STEREO MICROSCOPE SERIES
ACCU-SCOPE
®
73 Mal
l Drive, Commack, NY 11725 • 631-864-1000 • www.accu-scope.com
9
Assembling the Camera
To the C-mount (Fig. 7)
1.
Screw the C-mount adapter into opening
at the top of the trinocular viewing head.
2.
Loosen the Lock Screw on the C-mount
adapter and take off the C-mount connector
from the C-mount adapter.
3.
Screw the C-mount connector onto the
camera.
4.
Mount the camera with the C-mount
connector onto the C-mount adapter and
tighten the lock screw .
5.
Connect your camera to a computer or
monitor via a USB or HDMI cable.
6. Rotate the Zoom Knob to maximum
magnification, observe image on the
monitor and adjust the Focusing Knob until
the image is clear/focused.
7.
Rotate the Zoom Knob to minimum
magnification, adjust the focusing ring on
the C-mount adapter until the image is
clear/focused.
8.
Rotate the Zoom Knob to maximum
magnification to observe whether or not the
image is clear/focused. If not, repeat #6
and #7 above until image is clear/focused.
Replacing the Fuse (LED Models) (Fig. 8)
Before replacing the fuse, turn the power switch
to “O” (Off), and unplug the power cord from the
outlet and the microscope.
Pull out the fuse base from the fuse socket.
Remove the fuse from the fuse base and
replace with a new one. Reinstall the fuse base
into the fuse socket.
Plug the power cord into the base of the
microscope and then into a wall outlet. Turn the
power switch to “--” (On).
The LED base uses a 3.15 amp fuse.
①
②
③
④
Fig. 7
Fig. 8