AccuBANKER AB-5000 MG/UV User Manual - page 15
#
Oper
ation
Operation
Turning the Power ON
Banknote Physical Condition Selector
Counting Mode
To start operating the unit, turn it on by pressing the power switch located in the back.
The Physical Condition level indicator should be lit in the middle position when the power is on. Change
the level of this function by pressing the Banknote Physical Condition Selector as follows (in case the
error messageEdis displayed frequently).
a) For notes that are stained or printed dark, set the level indicator in the darker position.
b) For notes that are new or printed light, set the indicator in the lighter position.
The unit can work in two modes, free counting mode and batch counting mode.
Free Counting Mode
Batch Counting Mode
In this mode the machine counts all bank notes in the hopper.This mode will be set in case the
is selected on the Batch Number display by pressing the Batch Function button.
In this mode the machine counts the batch of bank notes assigned by the user.This counting mode
may be set by entering a quantity (any number up to 999 except
) on the Batch Number
Display. Before beginning the counting function, use the Batch Function button or keypad to set the
selected number or the
,and then begin counting normally.
blank
blank
blank
Note:
In the auto starting mode the next counting will start automatically by only removing the
counted batch notes from the stacker. In case the counting stops before the preset number has
been reached, refill the hopper.The machine will continue counting automatically.