Accucraft trains D&RGW K37 2-8-2 Instruction Manual - page 4
Instruction Manual -D&RGW K-37 Electric
Instruction Manual -D&RGW K-37 Electric
3
8
Technical Specifications:
Scale:
1/20.3, 45 mm Gauge
Minimum Radius:
1.2M (48 inch)
Power:
0-24V D, Pittman gear head motor
Weight:
28.5 lbs (12.94kg)
Locomotive Information:
Length:
26 inches (660.4 mm)
Width:
6.25 inches (158-75 mm)
Height:
8.0 inches (203.2 mm)
Tender Information:
Length:
16 inches (406.4 mm)
Width:
6.25 inches (158.75mm)
Height:
8 inches (203.2mm)
Recommended radius:
117.5 mm, 461/4 inches (LGB 1600)*
Recommended clearance: 3 inches from rail*
*Be sure to leave at least 3”clearance (measured from the inner rail) on the
46-1/4 inch radius curve to allow for overhang.
The following parts are packaged separately
-M2 hex head screws
-M2 hex head screw driver
Caution!
This model is an accurate replica of the original locomotive. It has sharp
and moving parts. The locomotive drive rods are stainless steel with sharp
edges.
OPERATORS MUST NOT COME INTO CONTACT WITH THE
MODEL WHILE IT IS BEING POWERED AT ANY TIME. UNDER NO
CIRCUMSTANCES SHALL ACCUCRAFT TRAINS BE RESPONSIBLE
FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
IN REGARD TO ANY ACCUCRAFT PRODUCT.
3.
The locomotive is firmly
taped to a 1/2 ” wood board
which is then fastened to the
metal case with 4 - M6 bolts.
Bolts must be removed before
lifting the locomotive with wood
board from the metal case.
4.
Place taped locomotive on
a flat surface. Carefully cut the
tape along the wood board side
surface. Be sure to cut the tape
on both sides of the wood board.
Slowly lift the tape from the loco-
motive. Be very careful with small
parts. Tape can not be re-used to
re-pack the model. Use new pack-
ing tape if necessary.