1. DL manuals
  2. AccuDome
  3. Security Camera
  4. ACD-1500-LG27
  5. Instruction Manual

AccuDome ACD-1500-LG27 Instruction Manual

Manual is about: Pan, Tilt and Zoom Dome Camera

Summary of ACD-1500-LG27

  • Page 1

    Instruction manual ver 3.0 pan, tilt and zoom dome camera / acd-1500-lg27.

  • Page 2

    2 pan, tilt and zoom dome camera / acd-1500-lg27 1 introduction features 3 components 4 system configuration 5 2 rs485 and ptz basics physical connection 6 multiple ptz setup 7 id, protocol, baud rate 9 3 installation wall mount 10 ceiling mount 11 final assembly 12 4 camera addressing camera addres...

  • Page 3

    3 pan, tilt and zoom dome camera / acd-1500-lg27 camera specification • sony module 480 lines • 27x optical zoom • 10x digital zoom • 3.25mm – 88mm zoom • 24v ac complete view • 360 degree pan, 90 degree tilt. For no blind spots housing • indoor / outdoor use, weather proof housing • multiple mounti...

  • Page 4

    4 pan, tilt and zoom dome camera / acd-1500-lg27 parts information item part no. Description dome camera and housing acd-1500-lg27 ntsc dome camera, weather proof housing, including transparent dome wall mount bracket bracket for mounting ptz to wall pendant mount bracket bracket for mounting ptz to...

  • Page 5

    5 pan, tilt and zoom dome camera / acd-1500-lg27 configuration part description • mount used to install camera housing • housing protects internal components from the elements •polycarbonate dome protects ptz camera • wiring access allows access to internal wiring • built in heaters keeps lens clear...

  • Page 6

    6 pan, tilt and zoom dome camera / acd-1500-lg27 rs-485 communication rs-485 communication is used to control a ptz camera. Standalone dvrs, pc-based dvrs, keyboard joystick ptz controllers, video servers, and a variety of other cctv equipment usually have an rs-485 interface (push terminals, d-sub ...

  • Page 7

    7 pan, tilt and zoom dome camera / acd-1500-lg27 baud rate is the data transmission rate in bps (bits per second). Both the controlling device and ptz must use the same baud rate. Most ptz camera and devices default to a baud rate of 2400 bps. The maximum theoretical transmitting distances of rs-485...

  • Page 8

    8 pan, tilt and zoom dome camera / acd-1500-lg27 multiple ptz (cont.) some circumstances require the use of a star configuration. The termination resistors must be set on the two devices that are the farthest distances away from each other, in this case #1 and #15 as seen below. As the star configur...

  • Page 9

    9 pan, tilt and zoom dome camera / acd-1500-lg27 ‰ ptz addressing and communication protocol before installing ptzs, you must understand 3 things: -ptz camera id -ptz protocol -ptz baud rate ptz camera id - each ptz camera in an install must have a unique id number assigned. Most ptzs default to id#...

  • Page 10

    10 pan, tilt and zoom dome camera / acd-1500-lg27 wall mount installation using outdoor housing assembly 1) attach the wall mount bracket to the wall. Make sure the wall can support the weight and vibration of the camera and housing. 2) remove thumb screw holding access cover in place on mounting ar...

  • Page 11

    11 pan, tilt and zoom dome camera / acd-1500-lg27 ceiling mount installation using outdoor housing assembly 1) mount the top ceiling mount bracket to the ceiling. Make sure the ceiling can support the weight and vibration of the camera and housing. 2) route the wiring through the bottom ceiling moun...

  • Page 12

    12 pan, tilt and zoom dome camera / acd-1500-lg27 5) unscrew polycarbonate dome cover counter- clockwise. 6) remove black camera cover inside of housing. 7) set dip switches according to protocol and baud rate desired. (see page 13 for details) 8) replace black camera cover and polycarbonate dome co...

  • Page 13

    13 pan, tilt and zoom dome camera / acd-1500-lg27 rs-485 communication rs-485 communication is used to control the camera. Rs-485 utilizes two wires, + and -. Protocol, baud rate and camera address are also required and are set using 2 sets of dip switch sets under the black camera cover inside the ...

  • Page 14

    14 pan, tilt and zoom dome camera / acd-1500-lg27 sw 1 : camera address settings (continued) when using more than 1 rs-485 device each unit must be given a unique address. Refer to the chart on the previous page for the value of each dip switch. For each dip switch that is on the value/values are ad...

  • Page 15

    15 pan, tilt and zoom dome camera / acd-1500-lg27 sw 2 : camera protocol and baud rate settings this camera supports multiple rs-485 protocols and baud rates which can be set using the sw2 dip switch located under the black camera cover. The table below contains a list of protocols supported by the ...

  • Page 16

    16 pan, tilt and zoom dome camera / acd-1500-lg27 once initial control of the ptz has been established by correctly connecting rs-485, setting matching protocol and baud rate in the ptz and controller, and the user is able to pan, tilt, and zoom additional features can be utilized. All basic functio...

  • Page 17

    17 pan, tilt and zoom dome camera / acd-1500-lg27 ‰ setting a preset position • kct-100: [n] + [preset] ex: to set preset 1, simply press 1, then preset • kct-2500: [preset] + [n] + [enter] ex: to set preset 1, simply press preset, then 1, then enter **there will be no notification of successfully s...

  • Page 18

    18 pan, tilt and zoom dome camera / acd-1500-lg27 ‰ auto cruise (tour) • kct-100: [51] + [preset] ex: to enable auto cruise, simply press 51, then preset • kct-2500: [preset] + [51] + [enter] ex: to enable auto cruise, simply press preset, then 51, then enter ** auto cruise continuously scans from p...

  • Page 19

    19 pan, tilt and zoom dome camera / acd-1500-lg27 all of the advanced functions of this camera are controlled by calling and setting specific presets to enable and disable the functions. This includes the osd (on screen display) setup on page 21. Your ptz controller must be able to call and set pres...

  • Page 20

    20 pan, tilt and zoom dome camera / acd-1500-lg27 iris mode: the iris mode can be set using this function or in the osd. Function action on controller iris mode – auto call preset 60 iris mode - manual set preset 60 white balance mode: the white balance mode can be set using this function or in the ...

  • Page 21

    21 pan, tilt and zoom dome camera / acd-1500-lg27 al on screen display (osd): the lg zoom camera installed supports an on screen menu for additional camera settings. To open the on screen display for the lg zoom camera, call preset 57 twice. Function action on controller open osd menu call preset 57...

  • Page 22

    22 pan, tilt and zoom dome camera / acd-1500-lg27 on screen display (continued) focus set menu: auto white balance (awb) menu: focus menu auto white balance menu 7 on screen display.

  • Page 23

    23 pan, tilt and zoom dome camera / acd-1500-lg27 on screen display (continued) auto exposure (ae) menu: special functions (special) menu: auto exposure menu special functions menu 7 on screen display.

  • Page 24

    24 pan, tilt and zoom dome camera / acd-1500-lg27 on screen display (continued) motion detection (motion det) menu: function on screen display (f osd) menu: motion detection menu function on screen display menu 7 on screen display.

  • Page 25

    25 pan, tilt and zoom dome camera / acd-1500-lg27 ‰ wiring: 24v ac terminal bnc connector for video out rs-485 communication terminal • screw terminal power connector: 24v ac wired directly to this plug. • video out bnc connector connect to units such as monitor, dvr, vcr and etc. • rs-485 communica...

  • Page 26

    26 pan, tilt and zoom dome camera / acd-1500-lg27 model acd-1500-lg27 video format ntsc device 1/4'' color ccd total pixel 410k pixels 811(h) × 508(v) h. Resolution more then 480 tv lines min. Illuminance 1.0 lux focus auto/manual camera iris auto/manual zoom 27x optical zoom, 10x digital zoom, tota...

  • Page 27

    27 pan, tilt and zoom dome camera / acd-1500-lg27 memo memo.