Acculab GSI-200 Instructions

M

odel

#GSI-200

#GSI-2001

INSTRUCTION

MANUAL

PLEASE READ COMPLETE

INSTRUCTIONS BEFORE USE

R

Specifications subject to change without notice.

as applicable

ACCULAB

Limited Warranty

Effective Date: January 1, 2003

Standard Terms and Conditions

Models: GSI series

ACCULAB warrants the product series "GSI" against defects in material and 

workmanship to the original consumer for a peroid of twelve (12) months or 

a maximum of fifteen (15) months from date of sale to authorized ACCULAB 

distributor. The warranty includes parts, labor and return shipping charges to 

customer (ground freight).

This specific warranty shall not apply to any product damaged due to accident,

misuse, abuse, lightning strike, power surges, improper packaging for shipment to

ACCULAB, or service/modification by anyone other than an authorized ACCULAB

Technician.

The purchaser's sole remedy, ACCULAB and its suppliers sole liability are set forth

herein. In no event shall ACCULAB or its suppliers be liable for any damages,

incidental or consequential, expenses, lost profits, lost savings, or any other claims

due to the use or inability to use the product/s. ACCULAB shall limit its obligations

under warranty to a time not to exceed the original product warranty period set

forth herein. This warranty gives you specific legal rights and you may have other

rights, which may be different from state to state.

In the event that service is required, the Customer/Distributor should call

ACCULAB (800-656-4400, extension 8342) for proper return authorization. The

product must be delivered to ACCULAB, Service Division 6542 Fig Street, Arvada,

CO., 80004 within the warranty period, freight charges prepaid. The customer is

responsible for product removal, installation and proper packing in order to 

prevent damage while shipping to ACCULAB Service facility. 

This limited warranty supersedes all other warranties pertaining to the ACCULAB

products, whether expressed or implied. Claims may be made by calling 800-656-

4400/631-254-4299, by fax 800-356-0338/631-253-5472, or in writing to:

                                          ACCULAB

                                                    Attn: Warranty Administrator

                                                              6542 Fig Street 

                                                           Arvada, CO., 80004 

                                                             (800-656-4400)  

ERROR CODE

Following is a description of typical error codes that may appear on

GSI-Series balances.

1)  

L

This indicates that the balance is under loaded.  Check to see

if the weighing pan is properly installed and seated on the top of

the unit. Performing the calibration procedure may cure this prob-

lem, otherwise, contact Acculab for repair.

2)  

H

This indicates that there may be an excessive weight applied

to the weighing pan. It is critical not to exceed the maximum load

capacity by more than 150% or damage to the balance may occur.

This may also be an indication that the unit needs to be calibrated.

Performing the calibration procedure may cure this problem, other-

wise, contact Acculab for repair.

3) 

ER 56

This code refers to an error generated due to a sensor

problem.  The most common cause is from objects being dropped

onto the weighing pan or from the balance itself being dropped.

Contact Acculab for repair.

4) 

ER 57

This code occurs when the electronics are no longer

within the factory set parameters. The most common cause is from

rough or improper handling of the balance. Contact Acculab for

repair.

R