AccuLine 40-6537 Instruction manual - Re-Calibration

Re-calibration

Referencing the results of the self-check and using the “h” mark (the

mid-point between the highest and the lowest point among A, B, C, D).

1. Enter self-calibration mode

a. Power off the instrument and face the X-axis towards the wall.

b. Press        button and         button simultaneously. Then

release the power button while still pressing the vibrate button.

Release the vibrate button after all LED flashes three times. The

laser will enter self-calibration mode and continuously rotates.

2. X-axis calibration

a. Opening the cover on the remote control, press the      

button, the X LED light on the laser keypad              flashes 

which means the laser has entered the self-calibration mode

for X-direction.

b. Press              button to make the laser beam move up and

down until it coincides with the “h” mark.

3. Y-axis calibration

a. Turn the instrument by 90º in self-calibration mode and

make Y-axis facing the wall.

b. Press          button, the Y LED light on the laser keypad

flashes which means the laser enters self-calibration mode for

Y-direction.

c. Press             button to make the laser beam move up and

down until it coincides with the “h” mark.

4. Self-calibration confirmation

Press          key after finishing re-calibration on both X and Y

12

©2008 Johnson Level & Tool

VIB

1467H-English  8/6/08  10:07 AM  Page 12