DL manuals
AccuQuilt
Cutter
Go! baby 55600UG
Instructions & Tips For Use

AccuQuilt Go! baby 55600UG Instructions & Tips For Use - 2. Turn.

Page of 8

Download

Print this page

Bookmark us

2. turn.

Push die, fabric and mat fi rmly against

roller. Roll through cutter.

3. done!

Remove mat and perfectly cut shapes!

Repeat process.

Keep hands and

fi ngers away from

rollers when operating.

Do not allow children

to operate unattended.

Use only with GO!

fabric cutting dies.

handle foam covered

die blades with care.

never place anything –

including extra mats,

fabric or shims – under

dies while cutting.

Always use a cutting mat.

Do not cut into steel roller.

Doing so will damage dies

and void the warranty.

how to operate your GO! Baby cutter

OPERAtInG

InstRUCtIOns

1. Place.

Layer die (with foam side up),

fabric and cutting mat.

die

CuttinG Mat

faBriC

For most accurate cuts, place fabric on the lengthwise

grain (see page 4). To conserve fabric, cover only

shape to be cut, not entire die board.

« ‹ Prev 1 2 3 4 5 6 7 Next › »

Summary of Go! baby 55600UG

Page 1
Instructions & tips for use.
Page 2: Welcome To
New to fabric die cutting? - take a little time to get acquainted with go! Baby. As you develop great die- cutting skills, you’ll see optimal use of your fabric. - check the orientation of the lengthwise grain before each cut. - practice cutting with scrap fabric. - test cut one shape before cutting...
Page 3: 2. Turn.
2. Turn. Push die, fabric and mat fi rmly against roller. Roll through cutter. 3. Done! Remove mat and perfectly cut shapes! Repeat process. - keep hands and fi ngers away from rollers when operating. - do not allow children to operate unattended. - use only with go! Fabric cutting dies. - handle fo...
Page 4
4 follow these steps to get perfect cuts every time 1. Go with the grain – for most accurate cuts, be sure you’re cutting on the lengthwise grain (straight of grain) as the fabric goes under the cutter. - the lengthwise grain runs parallel to the selvage edge—the bound edges of fabric that prevents ...
Page 5
3. Save your fabric! – when laying your fabric on the die, only place it right over the shapes you wish to cut. There is no need to cover the entire board. Two tone ™ foam makes it easy to align fabric just over the edge of the shape so you can save fabric. 4. Cut up to 6 layers at a time – the go! ...
Page 6
Accuquilt offers many different die shapes and sizes designed with features to save you time and to give you the most accurate cuts. Visit accuquilt.Com to see our wide selection of piecing and appliqué dies to use with your go! Baby fabric cutter. Go! Dies designed to save you time die tips - threa...
Page 7
Go! ® cutting mats go! Cutting mats are specially made for use with go! Cutters. - store mats flat and avoid direct sunlight. - extend the life of your mat by alternating the sides when cutting. - replace mat when cutting performance of die is reduced or mat shows excessive wear. - do not use warped...
Page 8
Find the full line of accuquilt ® products when you visit accuquilt.Com. Need help? Accuquilt customer support available 8 a.M.-5 p.M. Cst, monday-friday 888.258.7913 accuquilt.Com/gobaby ©2014 accuquilt patents pending 55600ug.