Accurex XRRS Installation, Operation And Maintenance Manual

1

Fire Ready Hood

Installation, Operation and Maintenance Manual

Please read and save these instructions for future reference. Read carefully before attempting to assemble, install, 

operate or maintain the product described. Protect yourself and others by observing all safety information. Failure 

to comply with instructions could result in personal injury and/or property damage!

WARNING

To reduce the risk of fire, electric shock, or injury 

to persons, observe the following:

•  Use this unit only in the manner intended by the 

manufacturer. 

•  Before servicing or cleaning unit, switch power off 

at service panel and lock the service disconnecting 

means to prevent power from being switched on 

accidentally. When the service disconnecting means 

cannot be locked, securely fasten a prominent 

warning device, such as a tag, to the service panel.

•  Installation work and electrical wiring must be 

done by a qualified person(s) in accordance with all 

applicable codes and standards, including fire rated 

construction codes and standards.

•  Sufficient air is needed for proper combustion 

and exhausting of gases through the flue 

(chimney) of fuel burning equipment to prevent 

backdrafting. Follow the heating equipment 

manufacturer’s guideline and safety standards such 

as those published by the National Fire Protection 

Association (NFPA), and the American Society 

of Heating, Refrigeration and Air Conditioning 

Engineers (ASHRAE), and the local code authorities.

•  When cutting or drilling into wall or ceiling, do not 

damage electrical wiring and other hidden utilities.

•  To reduce the risk of fire or electric shock, do 

not use this range hood with an additional speed 

control device.

•  Ducted fans must always be vented to the 

outdoors.

•  To reduce the risk of fire, use only metal ductwork.

•  Use with approved wiring only.

•  This unit must be grounded.

WARNING

To reduce the risk of range top grease fire:

•  Never leave surface units unattended at high 

settings. Boilovers cause smoking and greasy 

spillovers that may ignite. Heat oils slowly on low or 

medium settings.

•  Always turn hood ON when cooking at high heat or 

when cooking flaming foods.

•  Clean ventilation fans frequently. Grease should not 

be allowed to accumulate on fan or filter.

•  Use proper pan size. Always use cookware 

appropriate for the size of the surface element.

To reduce the risk of injury to persons in the event 

of a range top grease fire, observe the following:*

•  SMOTHER FLAMES with a close-fitting lid, cookie 

sheet, or metal tray, then turn off the burner. BE 

CAREFUL TO PREVENT BURNS. If the flames do 

not go out immediately, EVACUATE AND CALL THE 

FIRE DEPARTMENT.

•  NEVER PICK UP A FLAMING PAN. You may be 

burned.

•  DO NOT USE WATER, including wet dishcloths or 

towels - violent steam explosion will result.

* Based on “Kitchen Fire Safety Tips” published by 

NFPA.

Listed to UL 300A Standard

REPORT #1293

Model XRRS

Fire Ready Hood