Accurist W3300 Series Operating Manual - 3. Operating Your Balance
6
5.
If desired to use the draft shield ring (included with models W3300-120, W3300-
300, W3300-500), place it carefully over the Weighing Pan. The bottom edge of the
shield will fit on the outside of the 3 raised locating ridges.
6.
Attach the included AC/DC Power Supply adapter to a suitable electrical outlet, and
attached the DC plug end to the balance.
7.
The front display should turn on, and the balance will run through a start up
procedure.
8.
Upon completion of the start-up procedure, the display will light up and the display
will show 0.00.
9.
It is recommended to wait 30 minutes to allow the balance to equilibrate to
the room’s temperature before use.
10.
Note that the back light on the display will remain on when the balance is in
use. If the balance is not in use, and there is not a sample on the weigh pan,
the back light will turn off as an energy-saving feature. The W3300 balances
do not have an on/off switch. The power cord can be detached if desired to
turn off the power.
3. OPERATING YOUR BALANCE
It is always recommended to plug in and pre-warm your balance at least 30
minutes before use.
3-1 Display and Control Panel
Leveling Bubble