Accutire MS-5530 Owner's Manual - Read Carefully

READ CAREFULLY

TO INFLATE TIRES

Fig. 1

Fig. 2

Fig. 3

FOR INFLATABLES

Unless directions are followed, physical  injury or property damage may result.

When using the compressor, never leave it unattended.

Power required: 12 volts 10 amps. D.C.

This compressor is designed for occasional use only. Operation over an 

extended period of time will overheat the  unit and damage the compressor. 

A sluggish operation of the compressor  or if  the exposed metal fittings 

get too warm to  the touch should indicate to you that the unit has been 

operating too long and is overheating. When this occurs stop  the unit 

immediately, and let  it cool for approximately 30 minutes before resuming 

operation.

You may use a 12 volt battery charger to power this compressor, but it 

must be rated at 10 amps or more to avoid damage  to the compressor 

and for the  charger.

Do not use air inflator  on  high pressure tires such as those used on large 

trucks.

Place connector on input valve stem (Fig.1) and push down. Close thumb 

latch connector (Fig.2). Caution: Make sure the connector always touches 

the core of tire valve stem.

Plug power cord into cigarette lighter receptacle.(Fig.3)

Then set compressor on/off switch to "on" position.

When proper pressure is reached, set on/off switch to "off" position, unplug 

power cord and remove connector.

Select the suitable adapter and insert it into the connector. (Fig. 4) Close 

thumb latch.

1.

2.

3.

4.

1.

2.

3.

1.

2