Accutone Aquarius User Manual - page 2
!
In order to prevent damage to your hearing,
and the volume on your mobile phone/audio device to the lowest before
inserting the headset to your ears. Slowly increase the audio volume for optimal
performance.
Listening at high volume levels for any prolonged period of time will cause
permanent and irreparable damage to your hearing.
NEVER insert the earplugs into your ears without the silicon/memory foam earbuds,
as it may cause infections or injury to your ear canals.
Try the various sizes of silicon earbuds for the perfect fit, but remove them from your
ears slowly and carefully to avoid them from coming off and staying in your ears.
NEVER insert the earbuds too deep into your ears!!!
Noise-isolation headsets prevents most sounds from the surrounding,
or in situations where your attention is required.
ALWAYS set the volume control dial to
the middle
do not wear
the headset during driving
Different In-Ear Headset model comes with slightly different accessories, but
generally the following accessories are included.
3x pairs of
earbuds
silicon
A pair of
earbuds
memory foam
1x
phone converter
nokia
1x accutone
cable winder
1x headset leatherette
headset carrying case
Most In-Ear Headsets from Accutone comes with three different sizes of silicon
earbuds and a special-made memory foam earbuds. To replace an earbud, gently
twist and pull the bud from the nozzle and insert the replacement as shown above.
Before inserting a memory foam
earbud in your ear, squeeze and
gently twist it to the smallest size
and allow it to slowly regain its
form inside your ear.
Once the memory foam regain its
size (takes about 10 seconds) it
will have molded with the shape of
your ear canal forming a perfect fit.
From time to time, if you notice a slight deterioration in sound quality, it may be a
result of obstruction from your ear-wax build-up.
or any liquid
cleanser to clean the nozzle as this will damage the headset.
Remove the earbud from its nozzle as shown in the above section, use a standard
small-size cotton swab to gently wipe the nozzle clean, do not apply too much
force when cleaning so to avoid pushing the ear-wax into the nozzle chamber.
Do not use water