© 2005 598-1224-00 hardwired electronic chime ®.
-2- 598-1224-00 chime replacement installation important: proper installation requires a diode on the front door push button. See diode installation instructions (page 5) after completing steps 1 through 10 below. Note: electrical work must be in accordance with national and local electrical codes. ...
-3- 598-1224-00 8. Route wires through wire entrance hole in new chime base. 9. Mount chime base to wall using screws and anchors provided. (drill 7/32" diameter pilot hole for wall anchors.) 10. Connect wire “f” to screw terminal marked “front”. Connect wire “t” to screw terminal marked “trans”. Co...
-4- 598-1224-00 figure 4 - mounting snap-on type cover install chime cover place chime cover securely over base. • for hanging type cover: remove, turn over, and reinstall the cover pin (see figure 3). Hang cover on cover pin. • for snap-on type cover: apply pressure to the cover until it snaps into...
-5- 598-1224-00 diode installation instructions a small electrical component called a “diode” is required for this chime to play the entire eight-note tune. This diode must be installed on the terminal screws of the front door push button (see figure 5). If not already installed on push button, atta...
-6- 598-1224-00 troubleshooting chime does not sound: • check chime: disconnect wire from terminal marked “trans”. Have someone operate push button at front door while you mo- mentarily touch the “trans” wire to terminal marked “front”. You will see a small spark if push button, wiring, and transfor...
-7- 598-1224-00 one year limited warranty this is a “limited warranty” which gives you specific legal rights. You may also have other rights which vary from state to state or province to province. For a period of one year from the date of purchase, any malfunction caused by factory defective parts or...
-8- 598-1224-00 chime system wiring diagram f r o n t t r a n s r e a r r t f transformer front door push button with diode chime rear door push button (if applicable).
