Ace Plus EX-G028A User Manual

Summary of EX-G028A

  • Page 1

    Vga over single cat5 series ex-g028a vga over cat5 extender user manual ace plus corp. Headquarters : 9f-2., no. 190 sec. 2 jung shing rd.,hsin-dian, taipei, taiwan 231 tel: +886-2-2912-4201 fax: +886-2-2912-3164 website: www.Ace-plus.Com page 1 of 8.

  • Page 2: Safety and Notice

    Safety and notice the ex-g028a vga over cat5 extender has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the ex-g028a should be used with care. Please read and follow the safety instructions t...

  • Page 3: Introduction

    Introduction with only one cost effective cat-5e cable, the ex-g028a lets you extend vga (wuxga) to cover the distance up to 330m (1,000ft). The devices are composed of a transmitter and a receiver. The transmitter ex-g028a-tx is installed near the signal source, and the receiver ex-g028a-rx is plac...

  • Page 4: Ace Plus Corp.

    Ace plus corp. Headquarters : 9f-2., no. 190 sec. 2 jung shing rd.,hsin-dian, taipei, taiwan 231 tel: +886-2-2912-4201 fax: +886-2-2912-3164 website: www.Ace-plus.Com page 4 of 8 model name ex-g028a ex-g028 b technical ex-g028a-tx ex-g028a-rx ex-g028b-tx aka ex-g028a-tx ex-g028b-rx role of usage tra...

  • Page 5: Panel Descriptions

    Panel descriptions front panel — transmitting unit (ex-g028a-tx) 1 2 1. +5v dc power jack: connect to 5v dc power supply 2. Vga in: vga input from a video source rear panel —transmitting unit (ex-g028a-tx) 3 3. Rj-45 out: plug in a cat-5/5e/6 cable that needs to be linked to the rj-45 connector of t...

  • Page 6: Ace Plus Corp.

    Front panel — receiving unit (ex-g028a-rx) 4. +5v dc power jack: connect to 5v dc power supply 4 5 5. Vga out: vga output to a monitor rear panel —receiving unit (ex-g028a-rx) 6. Rj-45 out: plug in a cat-5/5e/6 cable that needs to be linked to the rj-45 connector of the transmitting unit ex-g028a-tx...

  • Page 7: Hardware Installation

    Hardware installation 1. Connect your vga source to the transmitting unit. 2. Connect your display to the receiving unit. 3. Connect your cat-5/5e/6 cable between the transmitting and receiving units. 4. Make sure your cat-5/5e/6 cable is tightly connected and not loose. 5. Plug in 5v dc power cord ...

  • Page 8: Limited Warranty

    Performance guide for vga over lan cable transmission performance rating type of lan cable wiring shielding cat5 cat5e cat6 unshielded (utp) solid shielded (stp) unshielded (utp) stranded shielded (stp) termination please use eia/tia-568-b termination (t568b) at any time the seller warrants the ex-g...