Ace Plus EX-G037 User Manual - Hardware Installation
1. Connect VGA or YPbPr source to the video input.
2. Connect S/PDIF or stereo audio source to RCA jack or 3.5mm jack.
3. Connect HDMI TV to the HDMI output connector
4. Power up the EX-G037.
Hardware Installation
EDID Learning
1. Power up the EX-G037. Connect display to
HDMI Output
.
2. To learn EDID from HDMI display, pull down the
DIP switch 1 to ON
, the green light
will be dark and bright to indicate the EDID learning process is complete. You DON’T
NEED to pull up the DIP switch again unless you want to learn another EDID by
pulling DIP switch 1 up and down.
Notice
1. Only HDMI enabled TV sets with
underscan/overscan
* support, the full active video
can be accurately displayed. Some HDMI equipped TV sets may not support this
feature. If underscan/overscan* is NOT supported, the top, bottom, left and right
border of the active video may be screened, and the S/PDIF audio may not sound
right.
2. Analog stereo audio can merely support 2-channel audio. This version does NOT
support 8-channel analog audio applications.
3. S/PDIF audio input supports the main 2-channel audio input
4. S/PDIF supports only 48KHz audio sample rate. Other than this rate, the input digital
audio should be adjusted to 48KHz in order to get audio signal correctly sent.
* The underscan mode displays the full video frame, which reveals content on the edge that is
recorded. In overscan, the field monitor zooms in to the area that would be visible on most
televisions. Set the field monitor to underscan if your video will be viewed on a computer
monitor or shown with a projector and also to look for light stands, microphones, and other
unwanted objects on the edges of your shot. Set it to overscan to see how the video will look on
a television.
ACE PLUS CORP.
Headquarters :
9F-2., No. 190 Sec. 2 Jung Shing Rd.,Hsin-dian,
Taipei, Taiwan 231
TEL: +886-2-2912-4201
FAX: +886-2-2912-3164
Website:
www.ace-plus.com
Page
8
of
9