Ace Plus EX-G073B User Manual

Summary of EX-G073B

  • Page 1

    Vga over single cat5 series ex-g073b vga & rs-232 over cat5 extender with rgb delay control user manual ex-g073b-tx ex-g073b-rx ace plus corp. Headquarters : 9f-2., no. 190 sec. 2 jung shing rd.,hsin-dian, taipei, taiwan 231 tel: +886-2-2912-4201 fax: +886-2-2912-3164 website: www.Ace-plus.Com page ...

  • Page 2: Safety and Notice

    Safety and notice the ex-g073b vga & rs-232 over cat5 extender with rgb delay control has been tested for conformance to safety regulations and requirements, and has been certified for international use. However, like all electronic equipments, the ex-g073b should be used with care. Please read and ...

  • Page 3: Introduction

    Introduction with only one cost effective cat-5e cable, the ex-g073b lets you extend vga (wuxga) to cover the distance up to 330m (1,000ft). The devices are composed of a transmitter and a receiver. The transmitter ex-g073b-tx is installed near the signal source, and the receiver ex-g073b-rx is plac...

  • Page 4: Ace Plus Corp.

    Specifications & package contents model name ex-g073a ex-g073b technical ex-g073a-tx ex-g073a-rx ex-g073b-tx aka ex-g073a-tx ex-g073b-rx role of usage transmitter [tx] receiver [rx] transmitter [tx] receiver [rx] video bandwidth 350mhz video support vesa transmission wuxga [1920x1200] — 330m (1,000f...

  • Page 5: Panel Descriptions

    Panel descriptions front panel — transmitting unit (ex-g073b-tx) 3 1 2 1. Rs-232 in : connect to a rs-232 signal source 2. Vga out : vga output to a remote video display 3. Led power indicator rear panel —transmitting unit (ex-g073b-tx) 5 4 6 4. +5v dc power jack: connect to 5v dc power supply 5. Vg...

  • Page 6: Ace Plus Corp.

    Front panel — receiving unit (ex-g073b-rx) 9 7 8 7. Rs-232 out : connect to a rs-232 receiving device 8. Vga out : vga output to a remote vga display 9. Led power indicator rear panel — receiving unit (ex-g073b-rx) 11 10 123 16 13 15 14 10. +5v dc power jack: connect to 5v dc power supply 11. Rj-45 ...

  • Page 7: Hardware Installation

    Hardware installation 1. Connect your vga and rs-232 source to the transmitting unit. 2. Connect your display and rs-232 receiving device to the receiving unit. 3. Connect your cat-5/5e/6 cable between the transmitting and receiving units. 4. Make sure your cat-5/5e/6 cable is tightly connected and ...

  • Page 8: Limited Warranty

    Performance guide for vga over lan cable transmission performance rating type of lan cable wiring shielding cat5 cat5e cat6 unshielded (utp) solid shielded (stp) unshielded (utp) stranded shielded (stp) termination please use eia/tia-568-b termination ( t568b ) at any time limited warranty the selle...