The contents are subject to change without prior notice due to product improvements and specification changes. Please read all instructions thoroughly before operating this device. Thunder tiger corporation guarantees this model kit to be free from defects in both material and workmanship. The total...
1 fspc-failsafe programmable individual channel in extremely rare circumstances where signal loss is encountered, the system features a failsafe program allowing individual channel to restore back to initial settings. Sibl-security id binding link a binding feature is included in the ace rc 2.4 ghz ...
Pistol grip 13bit led none 2 receiver item no frequency(mhz) channel bec modulation type battery power trs402ss aq6367 2.4ghz 4ch no ppm single antenna w / gain 4.8~7.4v receiver item no frequency(mhz) channel bec modulation type battery power trs401ss aq2280 2.4ghz 4ch no ppm single antenna 4.8~7.4...
Transmitter antenna power indicator edit buttons lcd display digital steering trim lever 1 2 3 4 5 digital throttle trim lever digital steering d/r(dual rate) lever aux ch button external charging jack 2.4ghz binding sw 6 7 8 9 10 steering wheel power switch throttle trigger steering tension adjustm...
Transmitter antenna battery level indicator hi/lo throttle atv (adjustable travel volume) servo reversing switches steering trim 1 2 3 4 5 throttle trim steering d/r (dual rates) aux ch button (for p3 only) external charging jack 2.4ghz binding sw 6 7 8 9 10 steering wheel power switch throttle trig...
5 transmitter controls ( for ps3i ) 1. Transmitter antenna: straighten up the antenna before operating the model. 2. Power indicator: the led light indicates power is "on" or "off". 3. Edit buttons: the left and right buttons are the "functions" selecting keys. The up(+) and down(-) buttons are the ...
While pressing this part battery cell (x8) for cougar ps3i battery cell (x6) for cougar p2 / p3 9.6v battery pack for cougar ps3i 7.2v battery pack for cougar p2 / p3 transmitter batteries replacement/installation 1) slide the battery cover in the direction as shown to remove the cover. 2) install 6...
Gas power model installation battery holder 4.8v rx battery pack ch1 ch2 batt steering servo throttle servo receiver electric power model installation motor 7.2v power battery pack ch2 ch1 esc receiver radio installation 1) connect the receiver, servos, and switch hardness/battery pack as shown. 2) ...
8 a binding feature is included in the ace rc cougar 2.4ghz spread spectrum system to ensure the transmitter and receiver bind properly and prevent interference from other controllers. To manually bind tx/rx, please proceed as per the following steps: a. Press and hold the “binding sw” button on the...
9 fail safe (f/s) function setting ace rc cougar 2.4ghz r/c system features a built-in failsafe function to automatically set a servo command if the receiver loses the signal from transmitter due to interference. For safety, we strongly recommend to active the failsafe function on your cougar r/c sy...
Fail safe (f/s) function setting 1. Steering:neutral 2. Keep brake or keep trigger at neutral pre-settings for f/s function: ep car : steering at neutral / esc at neutral gp car : steering at neutral / carb. At iddle f/s function activates 10 1 2 3 4 5 status boot-up green led flashing green led fla...
Menu value display status display trim position ruler functions ( for ps3i ) 11 there are 4 distinct areas on the screen: “menu”, “value display”, “status display”, and “trim position ruler”. Using the left and right “edit buttons”, the cursor will jump to the function you would like to edit. When y...
Audio on mode audio off mode epa position default 100% adjusting range 0%~150% 12 1) turn off the radio. 2) press the “up”(+) and “right”( ) buttons and hold them. 3) turn on the radio, a short “beep” is emitted (power on) , followed by a long “bi” tone (finish tone mode switching). Release the “up”...
13 note: if a servo’s maximum travel interferes with mechanical parts, it may cause linkage binding or even damage to the servo. It’s advised to first turn the steering wheel to the fullest and then adjust the epa to the suitable value and visually confirm no biding is occurring. 4.2) epa/th the epa...
14 5.1) arc/st the arc/st function adjusts the sensitivity of the steering servo responsiveness near the neutral position. This setting affects both left and right steering servo movements at the same time and by the same percentage. Negative steering arc setting provides lower sensitivity around th...
Default nor adjusting range nor/rev default h 0 adjusting range l125~h125 default r 0 adjusting range l125~r125 15 6. Model number 10 models can be saved in the radio memory code (model 0~9). The model no. Flashes on the display. Use up(+)/down(-) buttons to call the model you want to select. When t...
16 note be sure the steering trim on the transmitter is at the neutral position before you are trying to make an adjustment. Helpful hint when you install a servo, always check to be sure the servo is at its neutral position. ● servo travel changing the trim can affect the overall settings. When adj...
17 6. Steering d/r steering d/r allows you to change the steering travel while running by turning the dual rate dial as shown to correct over-steering and under-steering problems by increasing or decreasing steering sensitivity. You can adjust sensitivity of your model to your own preferences with t...
Using caution at the racing track 18 no.8227 cougar p2 2.4ghz 2ch radio system aq6367 2.4ghz 4ch rx, trs402ss ■ tx & rx accessories fcc interference statement do not operate the model or use the radio in rain, lightning, or at night. Do not operate the model or use the radio if you have been drinkin...
Ag2078 y switch harness, futaba 19 ag2051 switch harness, futaba & jr 2927 ni-mh battery 2/3a, 4.8v/1.2ah (4) for rx 2932 ni-mh battery 2/3a, 6v/1.2ah (2+3) for rx 2938 ni-mh battery 2/3a, 6v/1.2ah (4+1) for rx 2939 ni-mh battery 2/3a, 4.8v/1.2ah (2+2) for rx 2988 ni-mh battery aa, 7.2v/1.1ah(6) for...
20 8126 digital speed servos 12.5kg/6v,ds1213 8127 digital torque servos 14.5kg/6v,ds1015 8128 digital speed servos 12.5kg/6v,ds1313 8151 7.4v high voltage servo 3.9kg/7.4v,shv1504mg accessories ■ analog servos ■ digital servos 8114 standard servo 3.8kg/6v,s1903 8117 micro servo 2.0kg/6v,c1016 8118 ...
21 2.4ghz digital radio system.
22.
Do not try to operate your model if you find your radio is not working properly. Check out the radio as following steps. If you can not solve the problems then contact with the thunder tiger authorized distributor for service. Trouble shooting thank you for purchasing of the ace rc cougar radio. Thu...
