Acecad PenPaper 5x8 User Manual - Turn Penpaper On Or Off
2
Charge the digital pad battery
Use the included USB charge cable to connect digital pad to an USB power adapter or
to your computer to charge the digital pad battery.
Charging:
the right red LED lights up.
Full Charge:
the right red LED turns off.
Low Battery:
the right red LED slowly flashes.
Note!
You need to use a DC 5V USB power adapter to charge. (Such as USB power
adapter of your iPad or mobile phone.)
Note!
The full charge battery of digital pad lasts about 8 hours with continuous use.
Two Working Modes of PenPaper
Slide the switch on the right side of the digital pad to switch
the working mode of PenPaper.
Writing Mode for iPad:
The switch is on the lower
position for working with the PenPaper Note App in
your iPad.
HID Tablet Mode for Windows:
The switch is on the
upper position for being a Bluetooth tablet device in
Windows, supporting the Ink Tools in Microsoft Office.
Paper Notepad, the Writing Area and Thickness
Paper Notepad:
Use its notepad clip to hold a paper notepad in the notepad holder.
Writing Area and Thickness:
Use a 5" x 8" paper notepad up to about 50 sheets
of paper whose thickness is the maximum writing thickness about 6 mm (0.236").
The writing area is within the notepad holder but its upper boundary is indicated by
the carving lines on the digital pad.
Turn PenPaper On or Off
Turn it On:
Hold down the Power button until the right blue LED lights up. Then the
PenPaper is waiting for connection and the right blue LED rapidly flashes.
Turn it Off:
Hold down the Power button until the right blue LED turns off.
Auto-Shutdown:
If you have not use or put the digital pen on the digital pad within
the previous 30 minutes, the PenPaper automatically shuts down.
Slide
Switch
Writing
Mode
HID Tablet
Mode