Acer AcerPower 6500 User Manual

Manual is about: Acer AcerPower 6500: User Guide

Summary of AcerPower 6500

  • Page 1

    9;6\vwhp user’s guide.

  • Page 2

    Ii &rs\uljkw copyright 1997 by this company. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemi...

  • Page 3

    Iii ,03257$176$)(7 ,16758&7,216 1. Read these instructions carefully. Save these instructions for future reference. 2. Follow all warnings and instructions marked on the product. 3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp c...

  • Page 4

    Iv 9. Do not allow anything to rest on the power cord. Do not locate this product where persons will walk on the cord. 10. If an extension cord is used with this product, make sure that the total ampere rating of the equipment plugged into the extension cord does not exceed the extension cord ampere...

  • Page 5

    V 14. Replace battery with the same type as the product's battery we recommend. Use of another battery may present a risk of fire or explosion. Refer battery replacement to a qualified serviceman. 15. Warning! Battery may explode if not handled properly. Do not recharge, disassemble or dispose of in...

  • Page 6

    Vi &'5206dihw\:duqlqj danger invisible radiation when open. Avoid exposure to beam. Vorsicht unsichtbare laserstrahlung wenn geÖffnet. Nicht in den strahl sehen. Attention radiation du faisceau laser invisible. En cas d’ouverture. Eviter toute exposition aux rayons. Varo avattaessa olet alttiina nÄk...

  • Page 7

    Vii &dxwlrqrq/lwklxp%dwwhulhv caution danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer’s instructions. Advarsel! Lithiumbatteri - eksplosionsfare ved fejlagtig h...

  • Page 8

    Viii )&&&odvv%5dglr)uhtxhqf\ ,qwhuihuhqfh6wdwhphqw note: this equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of fcc rules. These limits are designed to provide reasonable protection against harmful interference in a residential install...

  • Page 9

    Ix $erxwwklv0dqxdo purpose this user’s guide aims to give you all the necessary information to enable you to operate the system properly. Manual structure this user’s guide consists of two chapters. Chapter 1 system board this chapter describes the system board and all its major components. It conta...

  • Page 10

    X conventions the following are the conventions used in this manual: text entered by user represents text input by the user. Screen messages denotes actual messages that appear on the screen. D , h , v , etc. Represent the actual keys that you have to press on the keyboard. Note gives bits and piece...

  • Page 11

    Xi 7deohri&rqwhqwv chapter 1 system board 1.1 features......................................................................1-2 1.2 system board layout .................................................1-3 1.3 esd precautions ........................................................1-4 1.4 pre-install...

  • Page 12

    Xii chapter 2 bios utility 2.1 entering setup ........................................................... 2-2 2.2 system information .................................................... 2-3 2.2.1 processor.................................................... 2-4 2.2.2 processor speed ...................

  • Page 13

    Xiii 2.3 basic configuration.....................................................2-9 2.3.1 date and time ...........................................2-10 2.3.2 floppy drives.............................................2-11 2.3.3 ide drives .................................................2-11 2.3.4 b...

  • Page 14

    Xiv list of figures 1-1 system board layout................................................. 1-1 1-2 installing the retention mechanism ........................... 1-6 1-3 installing a pentium ii processor ............................... 1-7 1-4 removing a pentium ii processor .........................