Acer homeplug usb adapter user’s manual.
-2-.
Table of contents 0.0 introduction to homeplug networking 0 . 1 p o w e r l in e n e t w o r k in g c o n ce p ts . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . 3 0.2 encryption and security ........................................... 3 0.3 basic requirements .............................
0.0 introduction to homeplug networking 0.1 understanding homeplug networking concept homeplug networking, not to be confused with power over ethernet, has very different usage and features. Power over ethernet is a device that acts as a hub or a switch and draws its power from nearby unsuspecting c...
Homeplug encryption and protection schemes the homeplug device uses encryption to block outside access. The key is set by using the configuration software on the cd. By default, the protection is enabled. However, it is recommended that you change the default encryption key. All your homeplug device...
The bridge function only works with ethernet homeplug models because usb devices can't be shared yet. The default connection type for ethernet adapters is bridge. The only way to turn it off is to install the utility that comes with the unit. That will turn the bridge into a node. It is possible to ...
1.0 installation - acer homeplug usb adapter make sure that your homeplug usb wall adapter is not plugged in when beginning. Insert the installation cd. If the cd does not automatically load, run (cd drive latter):\usb\setup.Exe click on next to start installation. Enter a username and organization ...
Click install. Click finish. -8-.
2.0 configuration with the homeplug configuration utility you will be able to configure and obtain status on your homeplug network. Just launch the newly created shortcut on your desktop. Device– on this window, the utility will try to detect what homeplug devices are connected. Your homeplug mac ad...
Network– this tab will show all homeplug devices connected to the network. Scan the network for newly added devices. Macaddress– the device id or macaddress is displayed on the tab to identify the unit. Data rate– shows the speed that this device is connected at. This data will vary depending on the...
Advanced– here users can do remote password changes. * device password (dek)is always taped on the bottom of the homeplug unit. -11-.
