Aircommand 8100001 Operating Instructions Manual

Summary of 8100001

  • Page 1

    Ibis 3 owners guide revision v1 page 1 of 19 ibis 3 owners manual contents warranty of refrigerated airconditioning ________________________________________________ 2 general unit information __________________________________________________________________ 4 packing list __________________________...

  • Page 2

    Ibis 3 owners guide revision v1 page 2 of 19 warranty of refrigerated airconditioning warranty within australia we undertake by this warranty to rectify, free of charge, at our nearest authorised service agent, any fault due to faulty workmanship or replacement of any faulty components within 12 mon...

  • Page 3: Installation & Operating

    Ibis 3 owners guide revision v1 page 3 of 19 head office aircommand australia pty ltd 954-956 port road albert park, sa 5014 acn 164 415 445 for warranty claims, sales enquires or customer service call: (08) 8345 8444 fax: (08) 8243 0628 email: service@aircommand.Com.Au installation & operating inst...

  • Page 4

    Ibis 3 owners guide revision v1 page 4 of 19 general unit information i. Purpose the aircommand ibis 3 air conditioning unit was designed for installation on the roof of a caravan or recreational vehicle to provide reverse cycle heating and cooling. The unit is intended for vehicles with roofs that ...

  • Page 5

    Ibis 3 owners guide revision v1 page 5 of 19 packing list the components of your ibis 3 will be contained in 2 cartons. Unpack the carton when you are ready to install and check that the contents are as below: main carton - 1160 x 890 x 250mm weight 47kg contents: 1. Ibis 3 roof top air conditioner ...

  • Page 6: Warning

    Ibis 3 owners guide revision v1 page 6 of 19 before installation you must complete the following steps checked that roof thickness is between 25 – 85mm. If roof is greater than 85mm thick you will need an ibis 3 thick roof adapter (part no 8102007) from aircommand. Note that this measurement must in...

  • Page 7: Warning

    Ibis 3 owners guide revision v1 page 7 of 19 installation mark out the position of the unit based on the following important requirements: before cutting holes through the roof ensure that mains power or battery driven inverters are disconnected the unit requires a 360 x 360mm square hole for instal...

  • Page 8

    Ibis 3 owners guide revision v1 page 8 of 19 2. Attach weather collar to roof locate the weather collar (item #1). The collar has one side marked “this side up ”. This top side will point to the sky. Figure 3 figure 3 - top side of weather collar showing this side up also has 4 grey foam strips arou...

  • Page 9

    Ibis 3 owners guide revision v1 page 9 of 19 4. Electrical supply this unit must be installed in accordance with as/nz 3001:2008 “electrical installations – transportable structures & vehicles including their site supplies’. Ensure that power is properly disconnected at the supply (mains and/or batt...

  • Page 10: Installation Is Now

    Ibis 3 owners guide revision v1 page 10 of 19 attach plenum assembly cont. Raise the plenum assembly towards the roof top installation. Engage a counter sunk screw into one of the 4 holes in the corner of the filter recess. Raise the plenum and engage the screw into its mating hole on the diagonal a...

  • Page 11

    Ibis 3 owners guide revision v1 page 11 of 19 commissioning of the unit turn the power on at the circuit breaker. Using the remote control (item #6) press the on/off button. Figure 17 . Each command from the remote control should be answered by a ‘beep’ from the receiver in the plenum. Figure 17 - t...

  • Page 12: Warning

    Ibis 3 owners guide revision v1 page 12 of 19 note: in heating mode the fan will not begin blowing air until the inside coil has reached a temperature of at least 30 ⁰c. This is to prevent cold draughts. Fan speed will increase to the set speed as the coil temperature increases. Press on/off button ...

  • Page 13

    Ibis 3 owners guide revision v1 page 13 of 19 general specifications model 8100001 roof top unit inside plenum height (mm) 222 32 width (mm) 848 535 length (mm) 1120 535 weight (kg) 45.4 2.7 aircommand australia pty ltd ibis 3 model no. 8100001 230v ac 50hz refrigerant 407c 870 g rated capacity cool...

  • Page 14: Warning

    Ibis 3 owners guide revision v1 page 14 of 19 operating instructions warning this appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction conce...

  • Page 15

    Ibis 3 owners guide revision v1 page 15 of 19 plenum status display (figure 26) in addition to the remote control there is a status display on the corner of the inside plenum. This row of lights indicates the mode that the air conditioner is operating in. The manual operation button can be used to a...

  • Page 16

    Ibis 3 owners guide revision v1 page 16 of 19 ibis 3 components & spare parts.

  • Page 17

    Ibis 3 owners guide revision v1 page 17 of 19 # part description part # qty 1 screw m5x12 - white 8101001 13 2 canopy - ibis 3 8101020 1 3 speed clip - m5 8101002 13 4 base - ibis 3 8101030 1 5 evaporator housing 8101005 1 6 evaporator fan deck 8101006 1 7 compressor, horizontal 240v ac r407c 001826...

  • Page 18

    Ibis 3 owners guide revision v1 page 18 of 19 ibis 3 wiring diagram.

  • Page 19

    Ibis 3 owners guide revision v1 page 19 of 19 trouble shooting guide symptom cause correction unit does not operate no power supply to unit check that mains power is plugged into van and that the supply is switched on. Check the van’s air-conditioner power circuit breaker is ‘on’ remote control is n...