1. DL manuals
  2. Aircommand
  3. Air Conditioner
  4. Jabiru
  5. Installation Instructions

Aircommand Jabiru Installation Instructions

Summary of Jabiru

  • Page 1

    Jabiru installation instruction version 3 issued 12/7/11 page 1 of 5 jabiru installation instructions step description 1 mark out centre line of the installation 2 align centre line of installation with the centre line of the "front panel cut out" template. Align "floor" on template with floor of ve...

  • Page 2

    Jabiru installation instruction version 3 issued 12/7/11 page 2 of 5 6 align centre line of installation with centre line of "rear exhaust cut out" template". Align fold in template with corner of floor and rear wall. Tape template in place 7 drill 4 x 10mm holes as marked on cut out template. Use j...

  • Page 3

    Jabiru installation instruction version 3 issued 12/7/11 page 3 of 5 9 stick the base sealing gasket around the perimeter of the cut outs in the floor 10 lay the metal slipper over the gasket with the folded end just outside the cupboard. 11 position the unit into the cut out. Slide the unit over th...

  • Page 4

    Jabiru installation instruction version 3 issued 12/7/11 page 4 of 5 13 locate three holes on the inside of the units sheet steel cover. Use screws provided to secure the unit to the bracing. Repeat for three holes on other side of unit 14 locate the control cable plug on the printed circuit board a...

  • Page 5

    Jabiru installation instruction version 3 issued 12/7/11 page 5 of 5 14 insert condenser duct through the hole in the external wall and inside the condenser air spigot. Ensure the duct is pushed in as far as possible. Trim excess duct so it is flush with outside wall. 15 insert external condenser gr...