Sparrow mk4 roof top air conditioner model number: 5860001 serial number: date purchased: warning it is important that this installation manual is properly read and understood before installation. The unit must be installed by a qualifi ed service technician. Failure to properly install the unit or ...
2 sparrow mk4 general information i. Purpose the aircommand sparrow air conditioning unit is designed for installation on the roof of a caravan or recreation vehicle to provide reverse cycle heating and cooling. • the roof must be capable of supporting the weight of the unit (29kg). • the mechanisms...
3 installation parts list main components 1 sparrow mk4 rooftop air conditioner 2 weather collar 3 black plastic duct 4 brace assembly 5 plenum fi lters x 2 6 plenum cover fittings & fixtures 7 m8x120mm bolts x 4 8 hold down bars x 4 9 plenum cover screws x 4 10 self tapping screws x 6 before instal...
4 before beginning, mark out the position of the unit considering the following important requirements: • the air conditioner should be situated as centrally as possible on the van, to ensure even air distribution. • the sparrow mk4 may be oriented in any direction to the normal direction of travel....
5 2. Assess roof strength • the roof members must be strong enough to support the weight of the unit without any roof defl ection that will cause “pooling” of water around the unit. Contact your caravan manufacturer to confi rm the max load the roof is able to handle. • if the roof does not have an ...
6 connection block at air conditioner rigid cable minimum area 1.5 mm 2 minimum 7 strand 15 amp 2 pole rcd minumum contact gap of 3mm in off position 15 amp power inlet brown y & g blue n a 4. Position sparrow on roof • remove the air conditioner from the carton and move to installation position. • ...
7 6. Assess roof thickness • measure the roof thickness and consult the table across to check if adjustments to the duct length are required. • note: if the duct length needs to be adjusted then cut the excess from the un-notched end. Roof thickness comment duct length bolt length (mm) (mm) 25 absol...
8 8. Attach duct to unit • raise the brace assembly and slip the black plastic duct over the outside of the fan outlet underneath the rooftop unit. Ensure that the notch cut in the plastic ductwork aligns with the fans power cable (fig 12). When attaching the duct to the unit take care to ensure it ...
9 9. Attach plenum cover connect the main cover of the plenum to the duct by attaching the blue suspension cord to the lug on the inside of the cover (fig 13). • this will allow you to use two hands to connect the control cable (fig 14). • connect the key pad control cables together (see below). Be ...
10 commissioning of the unit 1. Turn the power on at the circuit breaker. 2. Press the on/off button and press the mode button to select fan. 3. Cycle through the low, med and high fan speeds checking that all speeds run. 4. Set mode to cool, adjust temperature via up/down buttons to 4˚c below the d...
11 general specifi cations air conditioner height 205mm width 560mm length 975mm weight 26.6kg air discharge plenum height 65mm width 535mm length 555mm weight 2.4kg model number 5860001 electrical rating 240v, 50hz refrigerant 407c, 450g rated capacity cooling 2000w heating 2150w power input coolin...
12 reference description 1 5862022 top housing fi tting kit 2 5862001 top housing 3 5862033 bottom housing 4 5862015 inside fan eps housing 5 5861010 outside fan assembly 6 refer to aircommand service 7 5861006 electrical kit 8 5862010 inside fan assembly 9 5861002 consensate collector set 10 586100...
13 schematic wiring diagram.
14 troubleshooting it is important that any work performed on this unit is carried out by a qualifi ed service technician. Work by an unqualifi ed technician can be extremely hazardous and may result in property damage and/or personal injury. This aircommand air conditioner will display an error cod...
15 operating instructions sleep mode: lf the unit is operating in cool mode and the sleep button is pressed to highlight the sleep light, then the unit over the next one hour will automatically raise the set point by 1oc. Conversely in heat mode, the setpoint will be lowered 1oc. Timer: the timer ma...
16 for sales enquiries please email: sales@aircommand.Com.Au for warranty, service or technical enquiries please email: service@aircommand.Com.Au for spare parts enquiries please email: parts@aircommand.Com.Au aircommand europe locke leisure products the gables, stoneleigh road bubbenhall coventry c...
