1. DL manuals
  2. Airfield
  3. Toy
  4. 95A251
  5. Assembly Manual

Airfield 95A251 Assembly Manual

Summary of 95A251

  • Page 1

    Assembly: aileron (1) (2) (3) (4) install the . (5) install the main landing gear. (6) (7) install the front landing gear. Install the right and left main wings. Install the left and right horizontal wings. Install the left and right vertical wings. Spoiler install the nose cone. 95a251 wingspan : l...

  • Page 2

    1 specification: type pn#model cont.\burst current(a) battery cell nixx/lipo weight (g) bec output size (mm) w*l*h user progra m a-ztw3a bec ztw12003 3a\5a 3-10 nc \ 1-3 lipo 2.5 5v / 1a 11 x 17 x 4 yes a-ztw6a bec ztw12006 6a\8a 5-10 nc \ 2-3 lipo 5 5v / 1a 13 x 21 x 4 yes a-ztw8a bec ztw12008 8a\1...

  • Page 3

    2 settings: 1.Brake: on/off * on - sets the propeller to the brake position when the throttle stick is at the minimum position (recommended for folding props). * off - sets the propeller to freewheel when the throttle stick is at the minimum position. 2.Battery type: lipo or nicad/nimh * nicad/nimh ...

  • Page 4

    3 * very soft – provides initial slow 1.5 sec ramp-up from start to full rpm intended to protect delicate gears from stripping under instant load. This setting is recommended for either fixed wing models equipped with gearboxes and / or helicopters. * soft acceleration - provides initial slow 1 sec ...

  • Page 5

    4 ∨∨ ∨∨ ∨∨ ∨∨ very soft ∨ ∨ ∨ ∨ soft acceleration ∨∨∨ ∨∨∨ ∨∨∨ ∨∨∨ start acceleration 7 governor mode _*_ _*_ _*_ _*_ rpm off _**_ _**_ _**_ _**_ heli first range _***_ _***_ _***_ _***_ heli second range 8 motor rotation w w w w forward/ reverse 9 switching frequency // // // // 8khz \\ \\ \\ \\ 16k...

  • Page 6

    5 pack and wait 5 seconds to reconnect the battery and repeat the above steps. Normal esc start up procedure 1. Switch your transmitter on and set the throttle to its minimum position. 2. Connect the battery pack to the esc. 3. When the esc is first powered up, it emits two sets of audible tones in ...

  • Page 7

    6 esc throttle cable connected to receiver in the reverse polarity check the esc cable connected to the esc to ensure the connectors are in the correct polarity. Faulty esc replace esc motor doesn’t work and no audible tone emitted after connecting the battery but servos are working. Or motor doesn’...

  • Page 8

    7 motor restarts abnormally esc overheats possible rf interference at the flying field. The normal operation of the esc may be susceptible to surrounding rf interference. Restart the esc to resume normal operation on the ground to verify recurrence. If the problem persists, test the operation of the...