Airfield Audio Liminator 2 Owner's Manual

Manual is about: CLASS A DUAL TRANSFORMER STEREO COMPRESSOR

Summary of Liminator 2

  • Page 1

    Liminator 2 class a dual transformer stereo compressor owner’s manual www.Airfieldaudio.Com.

  • Page 2: Table of Contents

    Table of contents section page introduction 2 installation 3 front panel controls 4 operation 5 specifications 7 warranty and registration 8 - 1 - www.Airfieldaudio.Com.

  • Page 3: Introduction

    Introduction thank you for choosing airfield audio. Our many years of specializing in tech service, custom build and modifications to high end studio and professional audio installations are now being expanded with an exciting new product line. For the airfield audio liminator 2 we have analyzed mor...

  • Page 4: Installation

    Installation - 3 - 5 1 2 6 4 3 rear panel view 1. Important : set the mains switch on the rear panel to the correct voltage. 2. Be certain that the unit has a ½ amp fuse (115 vac mains) or ¼ amp fuse (230 vac mains). 3. Connect line level audio input cables from your source (microphone preamp, eq, a...

  • Page 5: Front  Panel

    Front panel - 4 - a b c d e f g h i j a. Threshold continuously variable adjustment. This control determines the amount of gain reduction. Fully counter-clockwise (ccw), gain reduction is off. Fully clockwise (cw), gain reduction is at maximum. B. Attack 5 position rotary switch, ccw: fastest, cw: s...

  • Page 6: Operation

    Operation all front panel controls are designed to be functional and uncomplicated. Initial control settings: 1. Set vu switch to system level: +4db is for standard analog signal level tracking and mixing, +14db is for digital mixing and mastering. 2. Set meters switch to “in”, and set ch1 and ch2 s...

  • Page 7

    11. Adjust release. This control determines the amount of time for the gain of a compressed signal to return to normal (or 0db reduction). Fast release returns the gain to normal quickly, which is useful for short-duration signal peaks. Slower release settings are less audible, useful in mixing and ...

  • Page 8: Specifications

    Specifications input impedance: 15k Ω with transformer 1, balanced, pin 2 hot 1.2k Ω with transformer 2, balanced, pin 2 hot output impedance: 75 Ω balanced, pin 2 hot frequency response: ± 0.25db, 20 hz to 20 khz - 2db at 10 hz, -2db at 68 khz with transformer 1 - 2db at 10 hz, -2db at 120 khz with...

  • Page 9: Warranty and Registration

    Warranty and registration airfield audio equipment is covered by a limited warranty against manufacturing defects in materials and craftsmanship for a period of two years from date of original purchase. Under the terms of this warranty, airfield audio inc. Will repair or replace the part or parts of...