AirKing 3016C Operating Manual - page 4
MODEL 3016C
OPERATION
1. Carefully remove the Fan from the plastic bag and the carton. Assemble unit per these instructions.
CAUTION:
Plastic or rubber tabs, like the feet on this unit, may stick to furniture surfaces and/or hardwood floors. The unit may leave a
residue that could darken, stain or leave permanent blemishes on the finish of certain furniture surfaces, including wood surfaces, and/or
hardwood floors.
2. Plug the cord set into a 120 volt outlet.
Be sure that the plug fits tightly into outlet.
When plugs fit loosely into receptacles, they may slip partially or completely out of the receptacle with only the slight movement
of the attached cord. Receptacles in this condition may overheat and pose a serious fire hazard; if covered by a curtain or drape,
the fire hazard is even greater.
3. After turning the Fan off, unplug the unit from the electrical outlet.
Rev. C 3/07
4
2084336
Rev. C 3/07
9
2084336
MODÈLE 3016C
OPERATION
1. OSCILLATION: Pull UP on the OSCILLATION KNOB
on the rear of the MOTOR. Turn FAN HEAD to left, right,
or straight ahead. Push OSCILLATION KNOB DOWN
and fan will oscillate about the set angle.
2. VERTICAL ANGLE: To adjust vertical angle, tilt FAN
HEAD up and down, as desired.
3. SPEED: Speed is controlled by either the PULL CORD
or the ROTARY KNOB located on the FAN BODY.
4. POWER SUPPLY CORD: Plug POWER SUPPLY CORD
into a wall outlet (120V AC, 60HZ).Store excess CORD
on the convenient CORD WRAP located on the back
of the FAN BODY.
Down: Oscillate
Up: Stationary
3
Bien caler la GRILLE ARRIÈRE et la fixer
avec l’ÉCROU PLASTIQUE en tournant
DANS LE SENS DES AIGUILLES D’UNE
ÉCROU
PLASTIQUE
2
MOTEUR
GRILLE
ARIÈRE
Aligner la découpe triangulaire "
s" de la GRILLE
ARRIÈRE avec le bossage triangulaire situé en
haut du couvercle avant du MOTEUR.
1
Incliner la TÊTE DU VENTILATEUR
en arrière. Placer la GRILLE
ARRIÈRE sur le MOTEUR.
GRILLE
ARIÈRE
MOTEUR
4
Glisser la PALE sur l’ARBRE DU MOTEUR. (Aligner la gorge du moyeu de la
pale avec la goupille située sur l’arbre du moteur.)
PALE
GORGE
GOUPILLE
5
Pour bien fixer la PALE, visser le CAPOT DE
MOYEU sur l’ARBRE
DANS LE SENS INVERSE
DES AIGUILLES D’UNE MONTRE jusqu’à ce qu’il
soit bien calé sur le moyeu de la PALE.
CAPOT DE
MOYEU DE
VENTILATEUR
16 po (41cm)
6
GRILLE AVANT de manière à ce qu’il soit à l’horizontale. Insérer le bas de la GRILLE AVANT
dans la GRILLE ARRIÈRE. La SAILLIE au bas de la GRILLE ARRIÈRE doit se trouver entre
deux BARRES de la GRILLE AVANT. Encliqueter l’AVANT dans l’ARRIÈRE en commençant
par le haut et en descendant des deux côtés. AUCUN CLIP DE GRILLE N’EST NÉCESSAIRE
POUR L’ASSEMBLAGE.
SAILLIE
PRESSIONS
ENJOLIVEUR
SAILLIE
PRESSIONS