Aironet 1000 series User Manual - page 15
7
Configuring the Access Point
To configure the Access Point so that it will communicate
with end nodes or Repeaters, you must first use the
Console Port to set the following parameters - SID,
Frequency or Datarate, Root Mode. If you choose to set an
IP address, remote access to the unit is possible via Telnet
or HTML browser.
The Console Port can be accessed directly by connecting
the Access Point to an EIA-232-E terminal emulation
program.
Console Port
To start the Console Port, set the EIA-232-E terminal (or PC
running a terminal emulation program) to
9600 Baud, No-
Parity, 8 data bits and 1 stop bit.
Power-on the Access Point and the terminal and then type
Yes or No when prompted for the ANSI or Teletype
command.
The Console Port consists of a main menu and a series of
sub-menus containing the configuration parameters from
the Menus. You simply type the name of the parameter or
the menu number and then press ENTER
.
Telnet Session
Telnet sessions can be disabled under
Configuration
Console Telnet Off.
Before starting a Telnet session to a remote Access Point,
you must first assign the unit an IP Address.