1. DL manuals
  2. Ansel
  3. IP Camera
  4. Pan/Tilt & Dome Type
  5. Quick Start Manual

Ansel Pan/Tilt & Dome Type Quick Start Manual

Manual is about: Multi-Profile Network Camera

Summary of Pan/Tilt & Dome Type

  • Page 1

    Multi-profile network cameras: pan/tilt & dome type quick start guide 2007 dec..

  • Page 2

    2 table of contents 1. System requirements ........................................................................................... 3 2. Physical installation.............................................................................................. 3 2.1 indoor ip dome camera installation.......

  • Page 3: 1. System Requirements

    3 about multi-profile multi-profile stands for simultaneously video streams. The network camera can generate mpeg4 and mjpeg streaming simultaneously to different clients. Moreover, the resolution can be different from one client to another. This state-of-art design is considerable to fit in various...

  • Page 4

    4 1. Rj45 lan socket: connect to pc or hub/switch. For connections to 10base-t ethernet or 100base-tx fast ethernet cabling. This ethernet port built n-way protocol can detect or negotiate the transmission speed of the network automatically. Please use category 5 “straight through” cable to connect ...

  • Page 5

    5 2. Directly install on any horizontal or vertical surface 3. Alternatively, fixed with wall mount bracket (option). 4. Camera adjustment: option: bracket 4.1. X-axis tilting view angle range is 0 o ~90 o 4.2. Y-axis rotating view angle range is 0 o ~90 o 4.

  • Page 6

    6 5. Connect the necessary cables and connectors: - plug-in ethernet cable into lan port (necessary) - connect the attached power adapter to camera and plug-in this adapter into power outlet (necessary) - connect video bnc connector to a local tv if necessary (to check camera viewing angle) 6. Done....

  • Page 7

    7 3. Set the proper image by moving the camera body (3-axis) and set the focus by turning the lens to the left or right direction. 4. When the camera focus adjustment has been completed, use the provided l-wrench to fasten the vandal-resistant housing to the main body. 5. When using the side conduit...

  • Page 8: Connections:

    8 - plug-in ethernet cable into lan port (necessary) - connect the attached 12v power adapter to camera and plug-in this adapter into power outlet (necessary) - connect video bnc connector to a local tv if necessary (to check camera viewing angle) 9. Done 2.3 p/t ip camera installation connections: ...

  • Page 9: P/t Ip Camera Installation:

    9 more information. P/t ip camera installation: ceiling mount 1. Fix the camera to l-type bracket with the two supplied screws 2. Fix the bracket and camera to the ceiling using two holly wall anchors and screws wall mount 1. Fix the l-type bracket to the wall using two holly wall anchors and screws...

  • Page 10: 3. Camera Administration

    10 3. Camera administration when you installed your networked device over your network environment, to start network camera web configuration, you must have the web browsers installed on computer for web management. - microsoft internet explorer 6.0 or higher at first, user may use “ip wizard” utili...

  • Page 11

    11 if difficulty is met, please refer to the following steps to establish the connection: - the networked device must be installed and powered on. - if the networked device’s default ip address (192.168.0.100) is already used by another device, the other device must be turned off until the device is...

  • Page 12

    12 mobile phone dialing procedure: step 1: contact your cell phone provider and make sure that 3gpp service is available . Support cell phone list please keep contact with your network camera sales. Step 2: enable “internet access” function on your mobile phone. Some telecom will automatically downl...