ANTAIRA uts-404a Installation Manual - 2. Plugging The Adapter
4S/8S RS232 to USB Multi Serial Adapter w/ Metal Case
2
Features:
Provides 4S (or 8S) RS232 Serial Ports over USB Port
Provides 4 (or 8) DSUB-9 Connectors
Baud Rate from 300 bps to 921.6Kbps
Supports 7,8 Data Bits
Odd, Even, Mark, Space, or None parity mode
Supports 1, or 2 Stop Bits
Supports USB Bus Power
DC Jack for Optional DC 5V Power Input
Optional Settings to Provide +5VDC power over pin#9 of
the DB9 RS232 Connectors.
Supports Win98, Me, XP, CE, Win2000, 2003
1. Connect the AC/DC Adapter if your USB bus power is not
enough to drive the whole unit.
2. Plug the Type-A end of the USB cable into the USB host port
of your PC or into an available USB port on a USB hub.
3. Plug the Type-B end of the USB cable into the back of this
unit.
4. Proceed with the next section “Installing Drivers” to install
the virtual COM port drivers for your Operating System.
The RS-232 Multi Serial Adapter can be hot-plugged to the USB
port of your computer due to the specifications of USB. It
supports the following operating systems. The drivers are
shipped in the following folder on the supplied driver CD.
1.
Driver Locations on the CD
These instructions are for installing the drivers from the CD
supplied with the product. If you are installing drivers for Win98,
ME, 2000 or XP, when prompted for the location of the drivers,