1. DL manuals
  2. Antares
  3. Battery Charger
  4. 91136
  5. Instructions For Installation And Use Manual

Antares 91136 Instructions For Installation And Use Manual

Summary of 91136

  • Page 1

    Battery equaliser dc line charger user manual, part no. 13328 issue 5 application type approval – information important safety information installation operation instructions for installation and use © 2003 fm 37786 iso 9002 antares (europe) limited chiltern hill . Chalfont st peter gerrards cross ....

  • Page 2

    Application the dc line charger is intended for the charging of auxiliary batteries on-board road-going vehicles. It is particularly suited to charging trailer batteries, where power is supplied through the 12s or 24s “suzi” socket, & current needs to be constrained to avoid overloading the socket &...

  • Page 3

    The best performance will be achieved with the line charger located as close as possible to the batteries to be charged, and connected with cables giving minimal voltage drop. If this cannot be achieved, then the remote battery voltage & temperature sensor should be used. Further guidance is given a...

  • Page 4

    The first connection to be made is the battery negative connection; one of the black wires (either will do) emerging from the dc charger should be connected directly to the negative terminal of the battery to be charged. The second connection is the other black wire; which should be connected to the...

  • Page 5

    Operation the dc charger is fully automatic in operation. Once installed, no further user action is required. The unit automatically switches on when a charging voltage is detected on the input supply. When a charging source is not present, it switches to a low power sleep mode. Specifications model...

  • Page 6

    Installation cable sizing cables & any connectors should be selected to carry the following maximum current: model input current (maximum) output current (maximum) all models 15 amps 33 amps 12 amps 30 amps input cables the line charger will operate successfully with the input voltage as low as 12 v...