Antari M-1 User Manual - M-1 Mobile Fogger

Other manuals for M-1: User Manual, User Manual, User Manual

Summary of M-1

  • Page 1

    User manual for the antari m-1 mobile fog machine congratulations on the purchase of your new antari m-1 mobile fog machine ‹ save and read these instructions ‹ bitte lesen sie und sichern sie diese anweisungen ‹ lisez et gardez ces instructions ‹ © 2007 antari lighting and effects ltd..

  • Page 2: M-1 Mobile Fogger

    2 m-1 mobile fogger introduction thank you for choosing antari’s m-1 mobile fogger. You now own a sturdy and portable state-of-the-art fog machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward t...

  • Page 3

    3 ƒ never aim the output nozzle directly at people. ƒ fog machine output is hot. Avoid coming within 50 cm of the output nozzle during operation. ƒ place the fog machine in a well-ventilated area. Never cover the vents on the front of the m-1. Never aim the output nozzle at open flames. ƒ the output...

  • Page 4

    4 setup ƒ remove all packing materials from the fog machine. Check that all foam and plastic padding is removed, especially in the nozzle area. ƒ fill with antari fog liquid (flm-05) or dealer recommended high-quality water-based fog fluid. Any other types of fluid can damage the unit. When filled, ...

  • Page 5

    5 ƒ to select operation mode 1. Slide the switch towards the back of the m-1 (towards the cap on the liquid tank). ƒ to select operation mode 2. Slide the switch towards the front of the m-1 (towards the nozzle). ƒ when an optional remote is connected, please see the detailed instructions for their ...

  • Page 6

    6 optional dummy battery and power adaptor set users can purchase the optional dummy battery and power adaptor for m1. (item number: dcp-12) the power adaptor can be used at ac100~240v power outlets. It can transform ac power into dc12v and power the m-1 by the dummy battery. Although the mobility o...

  • Page 7

    7 m-1 ͘೩ё໬ᙳ፟(ᄊ࿪ё)ֹϡᄲځ३ ऽಈଋјࠎ antari m-1 ͘೩ё໬ᙳ፟۞ֹϡ۰. 感謝您選用 antari 煙霧機產品,現在您已經擁有高科技的專業煙霧機,在開始使用之前,我們建議您 先仔細閱讀本說明書,遵循使用手冊中的說明,這會有助於您在使用 antari 煙霧機時得心應手,達到 最滿意的煙霧效果,對於機器的使用壽命也更為延長。 ፟ጡఢॾ! ƒ 煙霧輸出速率: 300 立方英呎/每分鐘 ƒ 功率: 75 瓦特 ƒ 油桶容量: 110 c.C. ƒ 電池規格: 直流 12v /2.3ah ƒ 耗油速率: 2c.C./每分鐘 ƒ 適用煙霧水: antari flm-05 煙霧...

  • Page 8

    8 ᔖҺ፼፵۞щБֹϡ͞ё ! ƒ 機器僅限成人使用,放置煙霧機之地點應避免兒童可及之處,機器使用中請時常注意機器狀況。 ƒ 煙霧機所產生的煙霧溫度較高,機器運作時,請遠離噴嘴 50 公分以上。 ƒ 請勿將機器噴嘴對著人體及動物直射。 ƒ 請將煙霧機放置於通風良好的地方,請勿遮蓋機器散熱部分,並勿將機器噴嘴對準火舌。 ƒ 當機器運作時,噴嘴輸出部分之溫度非常高,故請將任何物品放置遠離機器 50 公分以上。 ƒ 清潔、從事維護及收納機器時,請先確認機器已經完全冷卻。 ᔖҺᘕࠓ۞щБֹϡ͞ё ! ƒ 請勿將電池暴露在高溫下,遠離火舌並請勿任意在機器操作時,拆卸零件。 ƒ 請勿將任何可燃性液體( 如...

  • Page 9

    9 ƒ 請注入 antari flm-05 高品質煙霧油,並仔細蓋上油蓋。 ƒ 電池充電方式。請將充電器接上電源插頭,在接上電源時電池上的綠燈會亮者,然後將電 池連接充電。請注意首次使用電池必須充滿八個小時,往後充電時間大約 2~3 個小時。 ƒ 充完電後約能連續使用 10~12 分鐘。 ƒ 電池安裝至機器時,請注意方向(貼紙面朝上-如圖示)。 放置電池時請稍微傾斜機器,會更容易置入,銀色卡榫為固定電池之用。 請確認電池放置時的位置正確(如附圖)。 ƒ 當第一次按下按鈕時,機器把手前方的綠燈會閃爍,表示電池已經充電飽和。 ƒ 當紅色燈開始閃爍時,表示電池需要充電,但這時機器仍能稍微運作一陣短暫...

  • Page 10

    10 m1 機器可搭配兩種選購控制器 1. Mct-1 定時控制器: 此控制器是透過一條總長 8 公尺的電線與 m1 連接,內建設定的持續 煙霧輸出為 10 秒,而每次煙霧的輸出間距可透過控制器上的旋鈕來設定於 3 至 220 秒之間。 2. Mcr-1 無線控制器組:將無線控制器組的訊號接收器安裝上 m1,可利用發射器來控制噴煙 動作,發射訊號的有效距離在空曠處最遠可達 50 公尺。 選配的假電池及電源變壓器組 您可以選購 m-1 假電池和電源變壓器組(品號 dcp-12) 電源變壓器組適用於交流 100~240v 的電源,可轉換為直流 12v 的電壓並透過假電池來供 應 m-1 動作所需的...

  • Page 11

    11 ƒ 機器不使用需收納之前請先清潔機器並確定將油桶清空,拆下控制器與電源線收好,整套 機器與配件請存放於乾燥陰涼處,每月固定溫機一次,可保護機器較不受潮。.

  • Page 12

    12 c08m01001.