Antari M-1 User Manual - page 5
5
Plug the charged battery into the bottom of the M-1 Mobile Fogger with
the label face up.
1.
Lift-up the plate before inserting the battery.
2.
Make sure the battery is inserted on the right position (see photo).
The green light by the front of the handle will flash when the button is
first pressed. This indicates the battery has enough charge to power
the M-1.
When the red light starts to flash, the battery needs to be charged.
The machine will still be able to fog for a short period of time after the
red light begins flashing.
Operation
To generate smoke, press the button on the front of the M-1 Mobile
Fogger’s handle.
There are two operation modes that can be selected for the M-1.
1. Operation mode 1. Allows the fog machine to fog as long as the
handle’s button or the remote control’s button is pressed down. To
stop fogging, stop pressing the button!
2. Operation mode 2. Works on a press once to start and press again
to stop basis. In this mode, start fogging by pressing the button.
The M-1 will fog continuously until the button is pressed a second
time.
Use the small switch on the right side of the M-1. The switch is inside
the case and is adjusted through the small hole on the side of the
case.