1 w-715 fog jet user manual 2013 antari lighting and effects ltd. English.
2.
3 safety information please read the following safety information carefully before operating the machine. Information includes important safety information about installation, usage, and maintenance. Pay attention to all warning labels and instructions in this manual and printed on the machine. If y...
4 unpacking and inspection immediately upon receiving the machine, carefully unpack the carton, check all content to ensure that all parts are present and have been received in good condition. If any parts appear damaged or mishandled from shipping, notify the shipper immediately and retain the pack...
5 requirement for the machine refer to the label on the back of the machine. Always connect the machine to a protected circuit and ensure it is properly grounded to avoid risk of electrocution. Step 4: turn on the machine by connecting the power cord and turning the neutrik powercon. Heat up takes a...
6 to active volume mode to emit fog under 2-second jet mode [stop] to stop output or go back to main screen functions value description interval set 10-300 seconds interval time under timer mode duration set 2-15 seconds duration time under timer mode timer output 50-100% output volume under timer m...
7 set first: output volume setup - press [menu] button until lcd screen displays “volume output” and then press ▲ or ▼ button to set the output percentage from 50-100%. After finishing the above setting, go back to main screen by pressing [stop] button. To activate volume mode, press [volume] button...
8 dmx channel function channel dmx value range function 1 0 – 5 fog off 6 – 255 fog output 50 – 100% fog output 100% for 2 seconds (under 2-second jet mode) dmx connector pin assignment the machine provide 3 or 5 pin xlr connector for dmx connection. Diagram below indicate pin assignment information...
9 with the transmitter it is possible to emit fog via radio signal at maximum distance of 50 meters. Press the button “a” or “b”, to emit fog. *receiver the receiver is tested and pre-attached to the rear of the machine. The included transmitter has been registered to the machine before shipping. To...
10 2. Once wireless remote control function is activated, the lcd screen will display “wireless detect …” everytime when the machine is turned on; this allows new registration. Every new registration overwrites the previous memory. 3. One machine can be controlled by up to 5 transmitters while one t...
11 excessive dust, liquid and dirt built up will degrade performance and cause overheating. Technical specifications input voltage 110-120v 60hz 220-240v 50hz breaker 15a 250v (110v-120v) 9a 250v (220-240v) heater 1600w warm-up time 9 minutes (approx.) output distance approximately 5 m fluid tank ca...
12 c08w71500
