Summary of Sonata Elite
Page 1
Sonata elite user’s manual.
Page 2: Table of Contents
Table of contents introduction 1.1 quiet computing™ features ……...……………......………….....… 1 1.2 case specifications ….…………………………....…......…….....… 2 1.3 diagram ..……………………………………………..….…...........…. 2 hardware installation guide 2.1 setting up ...........................................……….…......……....
Page 3: Sonata Elite User’S Manual
1 at antec, we continually refine and improve our products to ensure the highest quality. It’s possible that your new case will differ slightly from the descriptions in this manual. This isn’t a problem; it’s simply an improvement. As of the date of publication, all features, descriptions, and illus...
Page 4
2 1.2 case specifications 1.3 diagram 1. 120mm blower fan (optional) 2. 120mm rear exhaust tricool™ fan 3. Supports mini-itx, microatx or standard atx motherboard 4. 3 x 5.25” drive bays 5. 4 x 3.5” drive bays 6. Power supply mount 7. Air intake 8. 2 x usb 2.0 ports 9. 1 x esata ports 10. Hd audio /...
Page 5
3 hardware installation guide 2.1 setting up 1. Place the case upright on a flat, stable surface. 2. Loosen the thumbscrews from the left side panel. Remove by swinging panel out. 3. Loosen the thumbscrews from the right side panel. Remove by swinging panel out. Note: do not use your fingernail to p...
Page 6
4 4. Lift and remove motherboard. 5. Screw the brass standoffs into the threaded holes that line up with your motherboard. Do not over-tighten the standoffs. Some standoffs may be pre-installed for your convenience. 6. Place your motherboard on the brass standoffs. 7. Fasten your motherboard to the ...
Page 7
5 5. Connect the appropriate connector(s) from the power supply to the hard drive(s) and the motherboard. 2.6 external 5.25” device installation there are three external 5.25” drive bays. 1. Carefully remove the metal plate covering the drive bay. 2. Make sure the clip on the end of the drive rail i...
Page 8
6 3.2 esata ports you will find a sata connector on a cable attached to the front ports. This internal sata connector is designed to connect to a sata connector on your motherboard. This will allow high-speed external hard disk enclosures such as the antec mx-1 to run at the same speeds as internall...
Page 9
7 3.5 rewiring motherboard header connectors if a case connector does not have the same pin-out as the corresponding motherboard header, it may need to be reconfigured. Examples could be for your usb header, audio input header, or some other front panel connector such as the power button connector. ...
Page 10
8 device regulates the fan speed by varying the voltage, which may start as low as 4.5v to 5v. Connecting a tricool™ fan set on medium or low to a fan-control device may result in the fan not being able to start because the already lowered voltage from the fan control device will be further reduced ...
Page 11: Antec, Inc.
Antec, inc. 47900 fremont blvd. Fremont, ca 94538 usa tel: 510-770-1200 fax: 510-770-1288 antec europe b.V. Stuttgartstraat 12 3047 as rotterdam the netherlands tel: +31 (0) 10 462-2060 fax: +31 (0) 10 437-1752 customer support: us & canada 1-800-22antec customersupport@antec.Com europe +31 (0) 10 4...