Antex Electronics tripleplay User Manual - page 9
XM-3000 TriplePlay Multizone Satellite Audio Receiver 9
© 2005 Antex Electronics, Inc.
•
When you enter a three-digit channel number, such as
1-5-5, TriplePlay automatically changes to that channel.
•
When you enter a two-digit channel number, such as 1-8,
you must then press the SELECT button for the channel
change to take effect. (If you enter the channel number as
0-1-8, TriplePlay will make the change automatically.)
When preset channels have been set, you can access those
presets simply by pressing the PRESET button, then an
appropriate numeric button. For example, if preset 0 were set to
Rock, preset 1 to Hits, and preset 2 to News, you could jump to
the News channel quickly by pressing “PRESET-2.” To return to
Channel mode, simply press the SELECT button once and
navigate normally to any desired channel in the line up.
Setting and Recalling Presets
Each zone can have 10 channel presets (numbered 0 to 9). To
assign a preset for the selected zone, first tune to a desired
audio channel. Press and hold the PRESET button for one
second, followed by a numeric button. For example, if you want
to set channel 44 to preset 9, press and hold the PRESET button
for one second, then press the numeric button “9.” Note that the
title bar display changes to “PRESET” to let you know that
TriplePlay is ready to assign a preset channel.
To recall a stored preset, press (but don’t hold) the PRESET
button and then the desired numeric button (0-9). Once the
desired preset has been entered the user must press the SELECT
button once to return to Channel mode operation.
Configuring Options
TriplePlay's SETUP mode allows you to configure TriplePlay
options (blocking, skipping, and adding channels) and obtain the
unit’s XM ID numbers for activation.
Entering SETUP Mode
To enter the SETUP mode, press and hold the POWER button for
four seconds. The menu shown in Figure 3 appears.
Note that in SETUP mode, the CHANNEL up/down buttons are
used to scroll though the menu options and the SELECT button is
used to confirm selections.
ADD OR SKIP
PARENTAL CONTROL
XM-3000 ID NUMBERS
SIGNAL STRENGTH
RETURN
XM-3000 TriplePlay SETUP
XM-3000 TriplePlay
ADD OR SKIP
PARENTAL CONTROL
XM-3000 ID NUMBERS
SIGNAL STRENGTH
RETURN
XM-3000 TriplePlay SETUP
XM-3000 TriplePlay
Figure 3 SETUP mode menu.
Blocking Channels
Using the Parental Control feature, you can block specific
channels so that they can be accessed only with a pass code that
you define. Parents find this feature useful for preventing their
children access to specific content.
To block a channel:
1. Press and hold the POWER button to enter SETUP mode.
2. Press the CHANNEL down button to highlight “PARENTAL
CONTROL,” and then press the SELECT button. A screen
similar to that shown below appears.