Anthem CD 1 Operating Manual
We at Sonic Frontiers hope you will derive many years of
listening pleasure with your new Anthem CD 1. This
Operating Manual contains important information regarding
the operation and care of the CD 1. Be sure to read this
manual carefully and follow these instructions in order to
keep it performing and sounding its best. Please contact
Sonic Frontiers if you have any questions - a Customer
Service Representative will be pleased to assist you.
W H A T ’ S I N T H E B O X ?
In addition to the CD 1, its cover, and the operating manual
you are presently reading (with associated inserts and
warranty card), there are a few more items to take inventory of
before steps are taken to make the Anthem CD 1 operational.
These items are:
• one 6922 tube
• a glove for handling the tube
• a detachable AC power cord
• 18 screws
• 1 Philips screwdriver
After completing an inventory of these items, proceed to
the next steps.
3/2/99 SKU#57553
T E C H N I C A L S P E C I F I C A T I O N S
INTRINSIC JITTER
of 10Hz-40kHz
POWER SUPPLY
EI-Laminate power transformer featuring
9 stages of power supply regulation
TRANSPORT MECHANISM
Sony (6 pack Vertical Changer)
Plays 5” discs and 3.5” discs
(3.5” discs - single play only)
HDCD FILTER/DECODER
Pacific Microsonics - PMD 100
D/A CONVERTER
Dual Burr-Brown PCM 1702P
TUBE COMPLEMENT
1-6922/E88CC in a high speed output
buffer configuration
ANALOG OUTPUT
1- pair single ended RCA
DIGITAL OUTPUT
1- AES/EBU on XLR male connector
1- S/PDIF on RCA Co-Ax connector
INFRA-RED OUTPUT
1 - via 3.5mm stereo jack
FREQUENCY RESPONSE
5Hz-20kHz ±.25dB
“A” WEIGHTED S/N RATIO
>-110 dB from 10Hz-20kHz
CROSS TALK
-75dB @ 10kHz
(>-65dB from 20Hz-20kHz)
THD
<.01 from>
MAX. OUTPUT LEVEL
Approx. 2 Volts
POWER REQUIREMENTS
100-120VAC ~ 50/60Hz (1A/250V Fast-Blo fuse)
220-240VAC ~ 50/60Hz (0.5A/250V Fast-Blo fuse)
70VA Maximum
DIMENSIONS
19” (48cm) W x 13” (33cm) D x
5.25” (13cm) H
NET WEIGHT
24lbs (11kg) unpacked
DANGER:
INVISIBLE LASER RADIATION
POSSIBLE WHEN THE TOP COVER
IS REMOVED. AVOID DIRECT
EXPOSURE TO THE LASER BEAM.