Anthro MiniCart GT23 Series Assembly Instructions - page 2
Anthro MiniCart
Assembly Instructions
Anthro
®
Corporation Technology Furniture
®
10450 SW Manhasset Drive Tualatin, Oregon 97062
Step 1
Before proceeding, please review the Assembly Instructions
of all Anthro products you purchased and are planning to
include in this installation.
Step 3
Attach three shelf supports to each shelf.
Begin by first installing a shelf clamp into the shelf notch.
Be sure the pointed barbs face towards the outer shelf
edge.
Next, slide a shelf support into the recesses of the shelf
clamp and shelf. Push in as far as possible.
Finally, secure with a 1-5/8” Clamp Screw (325-5086-00).
anthro.com
Step 4
Loosely attach one shelf to hole 14 from the bottom
(coped end)
of one vertical leg using a Self-threading Screw. These fasteners
are cutting threads into the leg, so the first few turns will require
some force.
NOTE: This will place your lower shelf 22” from the floor using the
standard 2
3
/
8
” casters.
Step 5
Loosely attach the remaining shelf to hole 2 from the top
(non-coped end) of the vertical leg assembly (from Step 4)
using one Self-threading Screw.
NOTE: Handle the shelf assembly carefully until the cart is fully
assembled.
Step 6
Loosely attach the 2
nd
and 3
rd
vertical legs to the shelf
assembly
(from Step 5) using one Self-threading Screw per
shelf support.
TIP: Use the holes in the vertical legs as a ruler to ensure that
your Self-threading Screws are installed into the correct
locations.
Questions? 1-800-325-3841
First
Next
Finally
Barbs
Step 2
Decide on the shelf locations for your MiniCart. You can
place your shelves almost anywhere on the vertical legs
(the
legs are stamped at 1” increments).
For a lower shelf location that is higher or lower than
19” from the floor, refer to the illustrations shown at right to
determine which holes to attach your lower shelf.
Once your MiniCart is assembled, it’ll take a little effort to
remove and reinstall it. Measure, measure, measure.
NOTE: These instructions will place your lower shelf 19” from
the floor using the standard 2
3
/
8
” casters.
GT23xx with 2
3
/
8
” Casters
GT23xx4 with 4” Casters
Hole 12=20”
Hole 11=19” (measured from the coped end)
Hole 10=18”
Hole 11=20”
Hole 10=19”
Hole 9=18”
REMINDER: You may want to
measure your equipment to make
sure it fits between the selected
shelf locations and adjust your
assembly as needed
Coped end
19”
19”
GT23xx
Overall MiniCart height is
28” using 2
3
/
8
” casters
NOTE: Add 1” to overall height for 4” casters and subtract 3” from
overall height for glides.
Bottom
(coped)
end
Hole 14=22”
(using 2
3
/
8
” Casters)
Insert one Self-threading Screw
through each Shelf Support
Top
(non-coped)
end
Hole 2
Top
(non-coped)
end
Bottom
(coped)
end
NOTE: These Instructions will create
approximately 6” of usable space
between your shelves.
Lower Shelf
Self-threading Screw
325-5010-00
Self-threading Screw
325-5010-00
Self-threading Screw
325-5010-00
1-5/8" Screw
325-5086-00