Arbe-iii instruction manual introduction arbe-iii is a solid state, fully regulated, universal power supply designed specifically for use of pre 1930’s battery operated radios. Three electronically isolated power sources are provided in one self contained unit. The high current “a” supply is continu...
B supply the “b” supply of the arbe-iii is designed to provide 5 different regulated dc voltages (22, 45, 67, 90 and 135 volts). The total “b” current available is 60 ma. This means that any combination of voltages used together should not exceed 60 ma. Each voltage can provide up to 30 ma at less t...
Voltage and current requirements for commonly used vacuum tubes tube type voltage current typical voltage used* 01a 5.0 vdc 0.25 amp 6.3 vdc ux201a 5.0 vdc 0.25 amp 6.3 vdc uv301a 5.0 vdc 0.25 amp 6.3 vdc uv201 or ux201 5.0 vdc 1.00 amp 6.3 vdc** ux99 3.0 vdc 0.06 amp 4.5 vdc ux199 3.0 vdc 0.06 amp ...
Reasons it is important to plug the arbe-iii into a 3 wire ac line or outlet. In addition, the (b-) terminal of the arbe-iii is capacitively coupled to the aluminum front panel. This provides an rf by-pass for your radio and effectively provides the ground your radio may require. Cautions when using...
The following actions can void your warranty the arbe-iii is warranted by antique radios inc. For a period of five year from the date of purchase. This product will be repaired (or replaced) by antique radios inc. If we determine that the product was used as intended and the failure was due to defec...
Limited 5 year warranty antique radios inc. Warrants to the original purchaser of this universal battery eliminator that, should it prove defective by reason of improper workmanship and/or material: (a) for 5 years from the date of original purchase at retail, warrantor will repair or replace, at wa...
