Anton/Bauer Hytron 100 Owner's Manual - page 7
5
SERVICE
In the unlikely event a HyTRON battery fails to deliver acceptable performance, it must be returned to the Anton/Bauer Customer Support
Department, the only facility qualified and equipped to service the InterActive 2000 HyTRON batteries and calibrate the electronic components
and sensors. Any attempt by the user or any other unauthorized persons to service this battery will surely result in improper calibration of the
electronic components resulting in severe battery damage and/or safety hazards to the operator, in addition to voiding any/all remaining uncon-
ditional or pro-rated warranty conditions.
Therefore:
1. DO NOT attempt to service this battery under any circumstances.
2. DO NOT send this battery for service to anyone other than the Anton/Bauer Service Department.
3. DO NOT rebuild this battery - At the end of its useful life contact the Anton/Bauer Service Department.
SPECIFICATIONS
HYTRON 140
HYTRON 100
HYTRON 50
OUTPUT VOLTAGE
14.4v Nominal
12 ~ 16.8v Operating
14.4v Nominal
12 ~ 16.8v Operating
14.4v Nominal
12 ~ 16.8v Operating
CAPACITY
(CELL CAPACITY)
140 WH Nominal
(10 AH Rated)
100 WH Nominal
(7 AH Rated)
50 WH Nominal
(3.5 AH Rated)
FUSE
12.5amp/125volt
12.5amp/125volt
Internal (7amp)
RECOMMENDED OPERATION
(MAXIMUM DISCHARGE RATE)
15-100 watts
(175 watts)
15-100 watts
(175 watts)
15-50 watts
(75 watts)
TYPICAL RUN-TIME
@ 20w – 7 hrs.
@ 25w – 5.6 hrs.
@ 40w – 3.5 hrs.
@ 20w - 5 hrs.
@ 25w - 4 hrs.
@ 40w – 2.5 hrs
@ 10w - 5 hrs.
@ 20w - 21/2 hrs.
@ 25w - 2 hrs.
WEIGHT
5.5 lbs
5.5 lbs
1.9 lbs
SIZE
5 5/16 x 4 1/2 x 3 3/4
5 5/16 x 4 1/2 x 3 3/4
5 1/4 x 3 1/2 x 2 1/8
Approved Copy