1. DL manuals
  2. Anton/Bauer
  3. Lighting Equipment
  4. ULTRALIGHT UL-D
  5. Owner's Manual

Anton/Bauer ULTRALIGHT UL-D Owner's Manual

Summary of ULTRALIGHT UL-D

  • Page 1

    One wor ld. O ne s mar t ch oice . ™ owner’s manual ultralight® system a7595-0086 rev n ( ul-s / ul-d) ® approved copy.

  • Page 2

    Table of contents 1 introduction quick change head module 2 removal of head module 3 proper bulb removal/replacement gold mount ® snap on battery bracket 4 ultralight ® filter accessories 5-6 ultralight ® dimmer accessories 6 mounting filters 7 12v bulb selection 30v bulb selection 8 specification s...

  • Page 3

    1 never attempt to remove or install a bulb while head module is attached to the base or install a bulb directly into the socket/base assembly. Introduction the ultralight ® is an extremely compact, lightweight, portable lighting system with almost total versatility. Weighing only 13 ounces, the qui...

  • Page 4

    2 removal of head module important: the head module must be removed before attempting to change any bulb. Caution: head module may be hot if the light has just been turned off. For proper head module removal, follow these instructions. 1. Pivot the head module foward to disengage the recessed screw ...

  • Page 5

    3 proper bulb removal /replacement for proper removal/replacement: 1. Follow the instructions on the previous page to remove the head module from the base of the light. 2. Using your thumbs, pull out on the hood tabs (see diagram) and rotate hood upwards. 3. Replace bulb and close hood of light ensu...

  • Page 6

    Ultralight ® filter accessories ultralight ® adapter accessories are detachable pivoting filter/lenses allowing the user to flip the adapter in and out of the beam pattern. Adapters (diffuser, wide angle, dichroic) are mounted in a holder, pivoted from a slotted tab into the space between the light ...

  • Page 7

    5 ultralight ® accessories (available separately) ultralight ® dimmer the ultralight ® dimmer (ul dimmer) can be mounted on all camera/camcorders via either the shoe mount or ¼-20 stud mount. Note: the ul2 that will be mounted on the ul dimmer needs to have the ¼-20 stud mount installed. This is sup...

  • Page 8

    Operating instructions adjusting the ul dimmer: - use the dial to adjust the dimmer from 0 to 100% - turn clockwise toward 100% - turn counter clockwise toward 0% programming the presets to reset: - to reset the preset, press & hold the dial inward for 4 seconds. To set presets: - to set a low prese...

  • Page 9

    12v bulb selection bulbs used by the ultralight ® are type mr16, tungsten-halogen bulbs. Spot or flood bulbs of any light distribution angle may be used. Low voltage bulbs – 12 to 14.4 volts. The ultralight ® offers the greatest versatility with the following low voltage bulbs. They can be powered f...

  • Page 10

    Specification lamps type mr-16 12-14 volts, 25-85 watts max. Current 8 amps; 200 watts, 4-6 amp typical for single bulb weight single base unit w/o bulb: 13 oz. Dual base unit w/o bulb: 19 oz. Size light head module: 2-1/4”w x 2-1/2”h x 2-13/16” dp service if you have any question about this or any ...

  • Page 11

    Limited warranty this one (1) year limited warranty for the product specified in this document (“product”) is given by anton/bauer, inc. (“anton/bauer”), 14 progress drive, shelton, connecticut 06484. If you (the purchaser of the product from anton/bauer, or the person for whom the product was purch...

  • Page 12

    Anton/bauer a vitec group brand the following are trademarks of anton/bauer, inc.: anton/bauer, anton/bauer logo and parallelogram design, aspekt, automatique, datatap, dionic, elipz, egripz, elightz, essentialz, gold mount, hubz, hytron, impac, interactive and design, lifesaver, logic series, logic...