1. DL manuals
  2. Anvil
  3. Power Tool
  4. AV-RT119
  5. Instruction Manual

Anvil AV-RT119 Instruction Manual

Summary of AV-RT119

  • Page 1

    Rotary tool instruction manual specifications voltage: rated input:135 w no load speed: 8000-33000min־¹ collet size: ø1.6mm, ø2.4mm, ø3.2mm wear hearing protection.Wear eye protection.Wear respiratory protection. Waste electrical products should not be disposed of with household waste. Please recycl...

  • Page 2

    Warning warning caution caution disconnect the plug from the power source before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. Housing cap collet collet nut collet nut to loosen to tighten collet wrench sp...

  • Page 3

    3.2mm collet 2.4mm collet 1.6mm collet identification rings collet nut balancing accessories — for precision work, it is important that all accessories be in good balance (much the same as the tires on your automobile).To true up or balance an accessory, slightly loosen collet nut and give the acces...

  • Page 4

    4.-operating speeds 5.- maintenance information sharpe wood carve wood deburr metal cut metal wear eye protection to select the right speed for each job, use a practice piece of material. Note: speed is affected by voltage changes. A reduced incoming voltage will slow the rpm of the tool. On the two...

  • Page 5

    Carbon brushes the brushes and commutator in your tool have been engineered for many hours of dependable service. In order to prepare your brushes for use, run your tool at full speed for 5 minutes under no load. This will properly “seat” your brushes, which extends the life of both your brushes and...

  • Page 6

    Environmental protection caution! Electrical products must not be thrown out with domestic waste. They must be taken t o a communal collecting point for environmentally friendly disposal in accordance with local regulations. Contact your local authorities or stockist for advice on recycling. No. Qty...