Audicom C100 Service manual
CAR RADIO CONFIGURATION
1
2
SWITCHES CONFIGURATION
SERVICES
CAN BUS/K-BUS
Compa ble with
ALPINE KENWOOD PIONEER CLARION
JVC LG PHONOCAR SONY BLAUPUNKT
Universal services can bus interface
ALFA R. FIAT LANCIA
OFF OFF OFF OFF OFF
ON
OFF
ON
AUDI
OFF OFF OFF OFF OFF
ON
OFF OFF
B.M.W.
OFF OFF OFF OFF OFF OFF
ON
OFF
CHRYSLER DODGE JEEP
OFF OFF OFF OFF
OFF
ON
ON
OFF
CITROEN PEUGEOT
OFF OFF OFF OFF
ON
OFF
ON
OFF
SWITCHES
1 2 3 4 5 6 7 8
OFF
ON
CAR MAKE
1
2
3
4
5
6
7
8
MERCEDES ML/R/GL
OFF OFF OFF OFF OFF
ON
ON
OFF
MERCEDES TRUKS
OFF OFF OFF OFF
ON
OFF
ON
ON
OPEL
OFF OFF OFF OFF OFF OFF OFF
ON
PORSCHE
OFF OFF OFF OFF
ON
OFF OFF
ON
VOLKSWAGEN SEAT SKODA
OFF OFF OFF OFF OFF OFF
ON
ON
RENAULT
OFF OFF OFF OFF
ON
OFF OFF OFF
ALPINE
KENWOOD
PIONEER
JVC
SONY
LG
CLARION
BLAUPUNKT
PHONOCAR
VM030.031
CAR AUDIO/LED
PHONOCAR
VM040
1
2
3
4
5
6
7
8
PHONOCAR
VM020.021.022
9
10 11 12
PHONOCAR
VM017
C.100
CITROEN C4,C5
OFF OFF OFF OFF
ON
OFF
ON
OFF
MERCEDES A/B/C/E/CL/CLS
OFF OFF OFF OFF OFF OFF OFF OFF
C100
Is a universal interface for cars with
CAN-BUS and K-BUS protocol.
It can detect some services passing through the
CAN BUS
such as: steering wheel controls, hand brake, igni on,
lights, odometer, reverse gear, amplifier control *
Services provided by C100 are only available
for cars with CAN BUS protocol, depending on
different cars features, note that not all cars are com-
pa ble with all the services available.
Amplifier control service is available for:
Chrysler, Dodge, Jeep.
ABer having installed the interface, you would need to configure the C100
according to the car radio brand by choosing the dedicated soBware.
Please follow the procedures explained below and
note that by default, C100 is usually set for ALPINE car radios.
Car Radio brand se-ng
Open the unit
Press and hold the key (1) un l the LED light (2) stays s ll, then release
the key (1)
Repeatedly press the key (1) un l you reach the number of flashes need-
ed
Now press the key (1) again, un l the LED light (2) stays s ll
Once this procedure is over, disconnect and reconnect the unitunit.
Close the unit.
Before installing the C100 interface, you need to configure it, ac-
cording to your care make and model you have to choose
the dedicated soBware .
ShiB the switches with care by using a small screwdriver
If your car is not among the above men oned list, please
refer to our web site for other compa bili es and installa on
manuals
www.audicom.it