1. DL manuals
  2. Audio Analogue SRL
  3. Amplifier
  4. Audio Analogue SRL
  5. Owner's Manual

Audio Analogue SRL Audio Analogue SRL Owner's Manual

Manual is about: Audio Analogue SRL INTEGRATED AMPLIFIER OWNER'S MANUAL

Summary of Audio Analogue SRL

  • Page 1

    Audio analogue soundpleasure puccini integrated amplifier owner’s manual manuale d’istruzioni.

  • Page 2

    Dear audiophile, congratulations and thank you for choosing the puccini special edition integrated amplifier. You have acquired an exceptionally musical, high-precision audio component, capable of extraordinary performance in any high-end system. Its refined circuit design yelds great sonic purity w...

  • Page 3

    Audio analogue puccini integrated amplifier owner’s manual manuale d’istruzioni 5 installation installazione 6 control comandi 7 connections collegamenti 9 operation funzionamento 11 remote control telecomando 12 safety precautions and maintenance precauzioni di sicurezza e manutenzione 13 specifica...

  • Page 4

    The shipping box should contain the following items apart from the amplifier and this owner's manual: remote control two aaa size batteries ac power cord warranty certificate please check if all has been included: if not, contact your dealer. After opening the box, carefully extract the amplifier an...

  • Page 5

    1 remote ir sensor sensore ir del telecomando aim remote control to this window to remotely operate the amplifier. Puntare il telecomando verso questa finestrella per agire da lontano sui comandi dell’amplificatore. 2 power / standby /fault indicator - spia di alimentazione / standby / guasto lights...

  • Page 6

    L r 6 phono ground / massa giradischi binding post for the turntable's earth wire. Collegamento per il filo di masso del giradischi. 7 phono input (ph1) / ingresso phono (ph1) uncommon on most of today's amplifiers, the puccini special edition offers an on- board phono preamplifier capable of interf...

  • Page 7

    Input connections collegamenti degli ingressi tape out connection collegamento dell’uscita tape pre out connection collegamento dell’uscita pre speaker connection collegamento dei diffusori 8 the amplifier has six pairs of source input rca sockets (one phono and five high-level line). As they are al...

  • Page 8

    Once all connections have been correctly made (please check twice!), make sure the volume control is turned completely anticlockwise then turn the unit on by pressing the power switch near the iec socket on the rear panel. On the front panel, the power indicator will glow red to indicate that the un...

  • Page 9

    Long and exhaustive listening tests have shown that the best sonic performance is obtained after a "burn-in" period of at least 100 hours. Once the unit is fully "burnt-in", best sound quality can be obtained after about 40 minutes warming up. Lunghe e complete prove d'ascolto hanno dimostrato che l...

  • Page 10

    Remote control telecomando in+ press to select next source. Pressing in+ when source 6 is selected gives source ph1. Premere per selezionare la sorgente successiva. Quando è selezionata la sorgente 6, la pressione di in+ seleziona la sorgente ph1. In- press to select previous source. Pressing in- wh...

  • Page 11

    Avoid opening the unit - no further servicing than that described in this manual should be attempted. Refer all servicing to authorised audio analogue dealers and qualified technicians. Do not expose the unit to heat - keep it away from heat sources such as direct sun, cookers, radiators, etc.. Do n...

  • Page 12

    Output power (1khz/230vac/ both channels driven) potenza d'uscita (1khz/230vac/ entrambi i canali attivi) 2 x 55w / 8 Ω 2 x 85w / 4 Ω line input impedance impedenza ingressi linea 50k Ω phono input impedance impedenza ingressi phono mm 47k Ω / 220pf; mc 100 Ω nominal line input sensitivity sensibili...

  • Page 13

    Slew rate slew rate > 10v/s bandwidth ( 0.1db) banda passante ( 0,1db) 20hz-20khz bandwidth ( 3db) banda passante ( 3db) 5hz-200khz (1w / 8 Ω ) channel separation (a 1khz, unused input shorted) separazione tra i canali (a 1khz, ing. Non usato a 0 inputs ingressi mm/mc phono (ph1), line 1/6 nominal v...

  • Page 14

    Power led off no sound power cord incorrectly inserted and/or amplifier switched off check that cord is inserted both in the integrated amplifier and in the mains wall socket and that the switch is in the 'on' position fuse burnt out check the fuse in the fuse holder (unplug cord from mains first!!)...

  • Page 15

    Led 'power' spento nessun suono cordone d'alimentazione non inserito correttamente e/o amplificatore spento controllate che il cordone sia ben inserito nell'amplificatore e nella presa di rete a muro, e che l'interruttore sia nella posizione 'on' fusibile bruciato controllate il fusibile nel portafu...

  • Page 16

    Audio analogue head office / ufficio commerciale: srl via c. Bottai, 88b 51015 monsummano terme (pt) italy tel. (+39) 0572 954513 · fax (+39) 0572 958099 e-mail: info@audioanalogue.Com r&d laboratory / laboratorio ricerca e sviluppo: via xx settembre, 12 56017 san giuliano terme (pi) italy www.Audio...